2. KLUS
  3. PLD-10-WP
PLD-10-WP

KLUS PLD-10-WP User manual

  • Hello, I'm your chat assistant. I've reviewed the mounting instructions for the KLUS PLD-10-WP Fastener. This document provides guidance on how to install the fastener and connect it to lighting fixtures and power supplies. It details the use of rods and wall fasteners, as well as how to mount and adjust the lighting fixtures.
  • What are the primary components for mounting the lighting fixture?
    How many fasteners should be used in relation to the fixture's length?
    Can the lighting fixture be adjusted after it's mounted?
*The full range of accessories and electronics is available at www.KlusDesign.eu
www.KlusDesign.eu
NOTE! All LED tapes must be connected to a 12 V or 24 V power supply.
IMPORTANT: Not all possible mounting procedures are presented here.
More mounting procedures and related accessories can be found at www.KlusDesign.eu.
Drawings of extrusions and accessories in these instructions are simplied and only
approximate the actual shapes.
1
PLD-10-WP Fastener – mounting instructions
1. PLD-10-WP Fastener (ref. 42292)
2. Rod*
3. Wall fastener*
4. Power supply (12 V / 24 V)*
5. Lighting xture*
1.
2.
3.
4.
5.
CLICK!
www.KlusDesign.eu 2
PLD-10-WP Fastener – mounting instructions
The lighting xture can be rotated
in the mounting brackets.
Mount the fasteners (1) on the rods (2)
and on the wall fasteners (3).
Connect the lighting xture (5)
to the 12 V / 24 V power supply (4)
and snap it in the fasteners.
It is recommended to use:
2 fasteners for 1 m of xture
4 fasteners for 2 m of xture
5 fasteners for 3 m of xture
I
II
III
5.
1.
2.
3.
4.
1.
2.
3.
/