KLUS K-10-WL Operating instructions

K-10-WL
Brand
KLUS
Model
K-10-WL
Type
Operating instructions
*The full range of accessories and electronics is available at www.KlusDesign.eu
www.KlusDesign.eu
NOTE! All LED tapes must be connected to a 12 V or 24 V power supply.
IMPORTANT: Not all possible mounting procedures are presented here.
More mounting procedures and related accessories can be found at www.KlusDesign.eu.
Drawings of extrusions and accessories in these instructions are simplied and only
approximate the actual shapes.
1
K-10-WL Fastener – mounting instructions
1. K-10-WL Fastener (ref. 42672)
2. Wire*
3. Wall fastener*
4. Power supply (12 V / 24 V)*
5. Lighting xture*
1.
2.
3.
4.
5.
CLICK!
CLICK!
www.KlusDesign.eu 2
K-10-WL Fastener – mounting instructions
Mount the fasteners (1) on the wires (2)
and on the wall fasteners (3).
It is recommended to use:
2 fasteners for 1 m of xture
4 fasteners for 2 m of xture
5 fasteners for 3 m of xture
Connect the lighting xture (5)
to the 12 V / 24 V power supply (4)
and snap it in the fasteners.
I
II
5.
1.
2.
3.
4.
1.
2.
3.
  • Page 1 1
  • Page 2 2

KLUS K-10-WL Operating instructions

K-10-WL
Brand
KLUS
Model
K-10-WL
Type
Operating instructions
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents