2. Right Weigh
  3. 201-EBT-12B
201-EBT-12B

Right Weigh 201-EBT-12B Installation guide

  • Hello! I am an AI chatbot trained to assist you with the Right Weigh 201-EBT-12B Installation guide. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!
INSTALLATION OVERVIEW
201-EBT-12B
This installaon overview is not a substute for reading the product manuals
WHAT’S INCLUDED
APPLICATIONS
Straight Truck: Spring Steer and Dual HCV Air
Drive Axle Groups
Sensor Locaon: Sensor Locaon:
Mode:
Mode:
The strain sensor should be located on the top, center of the steer axle.
See 221-SK manual for more informaon on how to install the sensor.
The air sensors should be connected directly to an air bag on each side
of the drive axle group. See 201-SK and 101-SK installaon manuals for
more informaon on how to install the air line connecons.
The strain sensor should be located on the top, center of the steer
axle. See 221-SK manual for more informaon on how to install the
sensor. Air sensor A should be connected directly to an air bag on the
li axle and air sensor B should be connected directly to an air bag on
the drive axle group. See 201-SK and 101-SK installaon manuals for
more informaon on how to install the air line connecons.
Set the gauge to Spring Average Air Average (SA AA) mode - separates
weight into front axle group (steer) and back axle group (drive). See
Air/Spring Suspension Gauge manual for informaon on how to set the
mode.
PP-003-0053 REV D
Spring Steer, Air Li Axle, and Air Drive Axle Groups
CONTACT US!
Right Weigh, Inc.
(888) 818-2058
www.rwls.com
[email protected]
Follow Us!
Set the gauge to Spring Average, Air Independent (SA Ai) mode -
separates weight into front axle group(steer), and two independent
air axle groups (li axle and drive axle groups). See Air/Spring
Suspension Gauge manual for informaon on how to set the mode.
1 x 201-217-32 - Gauge and mounng bracket
1 x 221-SK - Epoxy strain sensor installaon kit
SENSOR CONFIGURATION
The gauge should be set to detect 1 Spring Sensor. See Air/Spring
Suspension Gauge manual for more informaon on how to set the sensor
configuraon.
www.rwls.com
ON/OFF
HOLD 3 SECONDS
CALIBRATE
C
HIGH
1C
LOW
234
ENTER
MENU
i
EL-003-0004
1 2 3 4 C/H C/L - KG LBS
Scan here to see addional resources on our
website including full installaon manuals,
quick set up guides, and video tutorials!
1 x 201-SK - Air line and electrical installaon kit
1 x 101-SK - Air line installaon kit
A
A
/