2. Focal Point
  3. Seem 4 LED Asymmetric Angled Lens Recessed FSM4AL

Focal Point Seem 4 LED Asymmetric Angled Lens Recessed FSM4AL Installation guide

  • I have examined the provided installation guide for the Focal Point Seem 4 FSM4AL LED luminaire. This guide details the components, different installation configurations, and the proper procedures to install the luminaire in a grid ceiling. It also covers important safety information to prevent electrical shock. I am ready to answer any questions you might have about the product or its installation.
  • What should I do before starting installation?
    What is the standard tee height?
    What should I do to prevent electrical shock?
IS0588 Rev. C 2017 ©Focal Point, LLC 4141 S. Pulaski Rd., Chicago, IL 60632 | www.focalpointlights.com 1 of 3
5.00"
127mm
Seem® 4 LED Asymmetric Angled Lens
grid ceiling
FSM4AL
focal point
U -
individUal
frosted lens
s -
start of rUn
i -
intermediate
e -
end of rUn
key
power off
power on
Luminaires must be installed by a qualied electrician (check with local and national codes for proper installation).
To prevent electrical shock, disconnect electrical supply before installation or servicing.
attention
grid spacing for
all grid types
configUrations are rUn specific, please consUlt factory drawings before beginning installation.
parts shipped installed
shielding shipped loose
parts lists
tie-wire bracket
(12547)
rail & clip gUide
check rail & clip positions before installation. arrows indicate screw positions.
to change in the field remove and reinstall according to diagrams below.
g1: std 15/16" lay-in tile
g2: std 9/16" lay-in tile
std = 1-1/2" tee height, tall = 1-11/16" tee height
g4: tall 15/16" lay-in tile
g5: tall 9/16" lay-in tile
g3: 9/16" slot-tee tegUlar tile
t1: std 15/16" tegUlar tile
t2: std 9/16" tegUlar tile
t6: 9/16" node tegUlar tile
t4: tall 15/16" tegUlar tile
joiner bracket
(a16274-01)
tie-wire bracket
screw (72010)
(8-18 x 1/4 self tapping
screw)
WALL
joiner filler
(a15524-01)
lower joiner
bracket
(11920)
IS0588 Rev. B 2017 ©Focal Point, LLC 4141 S. Pulaski Rd., Chicago, IL 60632 | www.focalpointlights.com 2 of 3
Luminaires must be installed by a qualied electrician (check with local and national codes for proper installation).
To prevent electrical shock, disconnect electrical supply before installation or servicing.
21
make electrical connections
individUal installations
skip to step 10
row moUnt installations
repeat steps 4-9 Until
all Units are installed
3
5
4
make thrU-wire connections
910
a b c
7116 x2
8
Contractor is responsible for adequately reinforcing walls and/or ceilings to support luminaire weight. Focal Point, LLC accepts no responsibility for inadequately reinforced walls
and/or ceilings. The information contained in this drawing is the sole property of Focal Point, LLC. Any reproduction in part or whole without the written permission of Focal Point, LLC
is prohibited.
IS0588 Rev. B 2017 ©Focal Point, LLC 4141 S. Pulaski Rd., Chicago, IL 60632 | www.focalpointlights.com 3 of 3
4 5
driver service
31
a b c
2
/