PP HOW TO MODIFY THE RV50X GSM ROUTER APN SETTINGS.
© Quadient Page 3/6
How to connect to the router interface:
Link your computer on Ethernet port
Make sure the PC is in DHCP mode
Check connections:
– The routers must arrive already configured on field.
– It’s still necessary to check to make sure that the configuration was applied correctly.
– Be sure to fasten the cables, especially the antenna one.
– When the router is started all of the LED lights go green.
– Make sure to connect the Ethernet RJ45 cables
Use a straight Ethernet RJ45 cable to connect the router to your computer.
Your IP should be attributed by router = 192.168.13.100 or higher
Authorize the new network on your computer
• Click on “Work network” then “close”