2. BLOTZ
  3. B15-CS-005

BLOTZ B15-CS-005 Assembly Instructions

  • Hello! I've reviewed the instructions for the BLOTZ Fast Food Outlet model B15-CS-005. This document provides step-by-step guidance on how to assemble the model, including the walls, base, roof with supports, and tile sections, as well as, guidance on painting. I'm ready to help with any questions you may have about the construction of this model.
  • What type of glue is required?
    What tools may be needed during assembly?
    Is there a recommended painting style?
15mm Fast Food Outlet
B15-CS-005
Please read these instructions fully before starting construction.
PVA or equivalent glue will be required to stick sections together.
Sand paper can be used to gently clean any joints.
A sharp modelling knife will be required to remove sections from the sprue. Please use knives with due care and
remember to cut away from yourself at all times.
During the construction of this model, you may find it convenient to use pegs / elastic bands to hold pieces in place while
you allow glue to dry.
Remove the four wall sections and base from the
sprue.
Glue them together as shown above.
Leave to dry.
Take the roof and supports from the sprue.
Glue the supports around the roof as shown.
The roof well uses the pieces shown above.
Glue the short pieces into place, then attach the
longer pieces.
Turn the roof over and glue the four bracers into
place.
The foor tile pieces. Before attaching these we
recommend undercoating the model. (see below)
The tile sections in position.
The finished model.
Painting Guidelines
We undercoated the tile sections black (car undercoat spray) and the rest of the model white (car undercoat spray)
The panels and brickwork were then painted red (DIY / Emulsion paint) and the base was painted grey (DIY / Emulsion
paint)
/