BLOTZ BH0-ME-110, B20-ME-110, B20_ME_110 Assembly Instructions

I've reviewed the instructions for the Long Wall (Barracks) model kit. The document provides a clear step-by-step guide for assembling the model, from removing parts to completing the structure. It mentions the use of glue, a sharp knife, and suggests using pegs or bands during assembly. I'm ready to answer any questions you have about it.
What type of glue is needed?

What tool is required to remove parts from sprue?

Can I use something to hold the parts while the glue dries?

20mm Desert Fort – Long Wall (Barracks)

B20-ME-110

Please read these instructions fully before starting construction.

PVA or equivalent glue will be required to stick sections together.

Sand paper can be used to gently clean any joints.

A sharp modelling knife will be required to remove sections from the sprue. Please use knives with due care and remember

to cut away from yourself at all times.

During the construction of this model, you may find it convenient to use pegs / elastic bands to hold pieces in place while

you allow glue to dry.

Remove the pieces shown above from the sprue.

Glue them together as shown above.

Take the base and connector pieces.

Attach the sub-assembly to the base then add the

connector pieces.

[Optional] Glue the door behind the doorway.

Add the walkway/roof section.

Attach the front wall.

The finished model.