2. BLOTZ
  3. B15-ME-110

BLOTZ B15-ME-110 Assembly Instructions

  • Hello! I've reviewed the provided instructions for the BLOTZ Desert Fort B15-ME-110 model. This detailed guide includes step-by-step instructions with diagrams on how to assemble the model, including gluing sections, attaching walls, and adding the base. I'm ready to assist with any questions you may have about the assembly process.
  • What kind of glue is required for assembly?
    Is it necessary to use sandpaper?
    What tool is required for removing pieces from the sprue?
15mm Desert Fort – Long Wall (Barracks)
B15-ME-110
Please read these instructions fully before starting construction.
PVA or equivalent glue will be required to stick sections together.
Sand paper can be used to gently clean any joints.
A sharp modelling knife will be required to remove sections from the sprue. Please use knives with due care and remember
to cut away from yourself at all times.
During the construction of this model, you may find it convenient to use pegs / elastic bands to hold pieces in place while
you allow glue to dry.
Remove the pieces shown above from the sprue.
Glue them together as shown above.
Take the “roof”, back wall and connector pieces.
Attach the sub-assembly to the “roof” then add the
back wall and connector pieces.
[Optional] Glue the door behind the doorway.
Attach the front wall.
Add the base, gently slotting each lug into the
associated hole.
The finished model.
/