2. BLOTZ
  3. B20_ACC_004

BLOTZ B20_ACC_004, B20-ACC-004 Assembly Instructions

  • I have reviewed the instructions for the B20-ACC-004 model Bus Shelter. This document provides detailed steps for assembling the model, including attaching the seat, end walls, and roof sections. I am ready to answer any questions you may have about its construction.
  • What kind of glue is needed for assembly?
    What tool is needed to remove sections from the sprue?
    What can help to hold pieces in place while glue dries?
20mm Bus Shelters
B20-ACC-004
Please read these instructions fully before starting construction.
PVA or equivalent glue will be required to stick sections together.
Sand paper can be used to gently clean any joints.
A sharp modelling knife will be required to remove sections from the sprue. Please use knives with due care and
remember to cut away from yourself at all times.
During the construction of this model, you may find it convenient to use pegs / elastic bands to hold pieces in place
while you allow glue to dry.
Take the back wall and see (as shown above)
from the sprue.
Attach the seat to the back wall – on either side
depending if you want the advertising boards on the
inside or outside of the shelter.
Attach the two end walls.
Remove the roof sections from the sprue (see above)
Starting with the one at the back, glue each into
position.
/