BLOTZ B20_SR_002, B20-SR-002 Assembly Instructions

Hello! I'm here to assist you with the Fort Stairs B28-SR-002 model instructions. I have reviewed the document, which provides step-by-step guidance on assembling the model using glue, sandpaper and a modeling knife. Feel free to ask questions about any of the steps or features mentioned in the instructions.
What kind of glue is needed?

What can be used to clean the joints?

What tool is required to remove sections from the sprue?

28mm Fort Stairs

B28-SR-002

Please read these instructions fully before starting construction.

PVA or equivalent glue will be required to stick sections together.

Sand paper can be used to gently clean any joints.

A sharp modelling knife will be required to remove sections from the sprue. Please use knives with due care and remember

to cut away from yourself at all times.

During the construction of this model, you may find it convenient to use pegs / elastic bands to hold pieces in place while

you allow glue to dry.

Remove the supports and the steps from the

sprue.

Glue the steps into the non-etched side of one the

supports.

Then take the other support and (starting from

either the top or the bottom) attach it in position,

gently easing each step into place.

Glue the end support into position.

Attach the base.