2. BLOTZ
  3. B15-SR-002

BLOTZ B15-SR-002 Assembly Instructions

  • Hello! I've reviewed the instructions for the Fort Stairs B15-SR-002. This document provides a step-by-step guide for assembling the model, including information about required tools, adhesives, and best practices for assembly. I'm ready to answer your questions about this product and its assembly process.
  • What type of glue is required?
    What tools are needed?
    What can be used to hold pieces in place while glue dries?
15mm Fort Stairs
B15-SR-002
Please read these instructions fully before starting construction.
PVA or equivalent glue will be required to stick sections together.
Sand paper can be used to gently clean any joints.
A sharp modelling knife will be required to remove sections from the sprue. Please use knives with due care and remember
to cut away from yourself at all times.
During the construction of this model, you may find it convenient to use pegs / elastic bands to hold pieces in place while
you allow glue to dry.
Remove one of the supports and the steps from
the sprue.
Glue the steps into the non-etched side of one the
supports.
Then take the other support and (starting from
either the top or the bottom) attach it in position,
gently easing each step into place.
Glue the end support into position.
Attach the base.
/