2. BLOTZ
  3. B28-ME-216

BLOTZ B28-ME-216 Assembly Instructions

  • I have read the instructions for the BLOTZ City Wall Corner Bastion (Round) model. This document provides a step-by-step guide that covers everything you need to know to assemble the model, from removing the pieces from the sprue to adding the decorative sections. I'm here to answer any questions you might have about the assembly process or the model itself.
  • What type of glue is required for assembly?
    What tool is needed to remove sections from the sprue?
    What can be used to clean the joints during assembly?
28mm Ancient City Walls – Corner Bastion (Round)
B28-ME-216
Please read these instructions fully before starting construction.
PVA or equivalent glue will be required to stick sections together.
Sand paper can be used to gently clean any joints.
A sharp modelling knife will be required to remove sections from the sprue. Please use knives with due care and remember
to cut away from yourself at all times.
During the construction of this model, you may find it convenient to use pegs / elastic bands to hold pieces in place while
you allow glue to dry.
Remove the pieces shown above from the sprue.
Glue them together as shown above to create the
main supports.
Take the other supports and centre brace.
Glue them together as shown (see pic).
Attach the two main supports.
Add the base.
Attach the walkway section.
Take the front lower strips.
Starting at one side, begin to add the sections.
Once all these pieces have been added.
Take the wall pieces.
Add them to the model.
The decorative strip sections.
Attach these into place.
The finished model.
/