Danfoss SpeedUp Eco Wall Heating - Wet plaster User guide

Application Sheet

SpeedUp Eco Wall Heating

Wet plaster

1 Wall heating dowel, 3-part, 70 mm

2 Danfoss wall heating metalgrid

3 SpeedUp Eco panel, 30 mm

4 Danfoss composite pipe 16 x 2 mm

5 Heating plaster over SpeedUp, 15 mm

Technical Data Wall heating with wet plastering

Wall covering 15 mm Heating plasters over SpeedUp; single layer plastering, edge

insulation strips required

Constructional thickness 45 mm Dimensions without unﬁnished wall, without tiles

Thermal resistance R 0.75 m²K / W Thermal resistance value for SpeedUp Eco panel

Pipe spacing 125-250 mm EZ = 125; CZ = 250;

Requirements and specialities Heating plasters must show a good thermal conductivity. Light plasters and heat insula-

tion plasters are not suitable.

Surface smoothness +/- 3 mm per 1m. Observe building regulation requirements con-

cerning thermal insulation. Moisture condensation can occur and should be taken into

consideration when planning wall heating on outer walls and walls between heated and

unheated rooms.

Wall coverings Heating plasters

Cement-lime plaster e.g. Stud: MP75 G/F, MP75 G: Thermal conductivity: 0.58 W/mk;

single layer processing; max. VL temperature: 50°C; heating according to report possible

after 3rd day.

Loam rendering e.g. Claytec: Final coat (05.010 / 05.012 / 10.012); Thermal conductivity:

0.65 W/mK; single layer processing; max. VL temperature: 50°C; heating possible im-

mediately.

Chalk-cement plaster e.g. MARMORIT ROTKALK; biorit 110: Thermal conductivity: 0.87

W/mK; two-layer processing; max. VL temperature: 65 - 70°C; heating according to

report possible after 8 days.

Construction Refering to EN 1264

Construction number 613