2. Danfoss
  3. SpeedUp Eco - Cement screed

Danfoss SpeedUp Eco - Cement screed User guide

  • Hello! I am an AI chatbot trained to assist you with the Danfoss SpeedUp Eco - Cement screed User guide. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!
Application sheet
SpeedUp Eco
Carpet / tiles / parquet / laminate / synthetics
Cement-screed
1
2
3
4
5
1 Carpet / tiles / parquet
2 Cement-screed (≥ CT-F4) 45 mm
3 SpeedUp Eco system foil
4 SpeedUp Eco heat panel + FH composite pipe 30 mm
5 Support batten (30mm)*
6 Wood bre insulation 30 mm
7 SpeedUp Eco perimeter insulation
8 If necessary moisture barrier
Floor nish NA mm Carpet / tiles / parquet / laminate / synthetics
Construction height 105 mm Height excluding oor nish
Weight ~ 102 kg / m² Weight excluding oor nish
Thermal resistance R 1,35 m²K / W The minimum thermal resistance requirement of DIN EN 1264 is
fullled.
Thermal transmission coecient U 0,66 W / m²K If the architectural design species better thermal insulation, this
must be taken into account.
Design load ≥ 2,0 kN / m²
Point load (≥ 20 cm²) ≥ 1,0 kN Sum of point loads not exceeding rated design load; particularly
heavy objects (such as aquariums and bathtubs) must be consid-
ered separately.
Impact subsonic noise reduction 26 dB Calculation value according to DIN 4109 on massive construction
Application area
Residential spaces, hallways and attic spaces in residential buildings and hotel rooms.
Corresponds to categories A1, A2 and A3 of DIN 1055-3.
Requirements & special features
Structural sealing according to DIN 18195 must be placed beneath the oor panel in case
of structures facing the ground, and otherwise on the unnished oor. The R value must
be increased if the groundwater level is less than or equal to 5 m. A U value not exceed-
ing 0.5 W/m²K must be maintained in existing buildings and additions with areas up to
50 m². * Construction without a stabilising support batten is also possible. Observe all
installation instructions and manufacturer’s instructions.
Additional insulation
30 mm wood bre insulation, WLG 045; existing buildings: 40 mm WLG 040
Construction
according to EnEV, EN 1264, DIN 1055, 4109, 18195, 18202 and 18560
Construction number 95
Technical Data Floors/ceilings facing unheated rooms or the ground
6
7
8
© Danfoss 11/2008
VA.CS.P1.02
Danfoss HES
/