Danfoss BasicRail Wall Heating in wet plaster User guide

Application Sheet

BasicRail Wall Heating

Wet plaster

1 Wall heating dowel, 3-part, 70 mm

2 Danfoss Wall heating metalgrid

3 BasicRail

4 Danfoss composite pipe 16 x 2 mm

5 Heating plaster, 35 mm

Technical Data Wall heating with wet plastering

Wall covering 35 mm 15 mm heating plaster over composite pipe

Constructional thickness 35 mm Dimensions without unﬁnished wall

Thermal resistance R: - m²K / W This wall heating construction does not include any

insulation.

Pipe spacing 120-200 mm EZ 2 = 120; EZ 3 = 150; CZ 1 = 200;

Requirements and specialities Heating plasters must show a good thermal conductivity. Light plasters and heat insula-

tion plasters are not suitable.

Observe building regulation requirements concerning thermal insulation. Moisture con-

densation can occur and should be taken into consideration when planning wall heating

on outer walls and walls between heated and unheated rooms.

Wall coverings Heating plasters

Cement-lime plaster e.g. Stud: MP75 G/F, MP75 G: Thermal conductivity: 0.58 W/mk;

single layer processing; max. VL temperature: 50°C; heating according to report possible

after 3rd day.

Loam rendering e.g. Claytec: Final coat (05.010 / 05.012 / 10.012); Thermal conductivity:

0.65 W/mK; single layer processing; max. VL temperature: 50°C; heating possible imme-

diately.

Chalk-cement plaster e.g. MARMORIT ROTKALK; biorit 110: Thermal conductivity: 0.87

W/mK; two-layer processing; max. VL Temperature: 65 - 70°C; Heating according to

report possible after 8 days.

Construction: Refering to EN 1264

Construction number 621