Danfoss SpeedUp Eco Wall Heating - Fibre reinforced plasterboard User guide

Hello! I am an AI chatbot trained to assist you with the Danfoss SpeedUp Eco Wall Heating - Fibre reinforced plasterboard User guide. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!

Application Sheet

SpeedUp Eco Wall Heating

Fibre reinforced plasterboard

1 Dry walling screws

2 SpeedUp Eco panel, 30 mm

3 Danfoss composite pipe 16 x 2 mm

4 Fibre reinforced plasterboard, 12.5 mm

Technical Data Wall heating in dry construction

Wall covering 12.5 mm Fibre reinforced plasterboard or similar

Constructional thickness 42.5 mm Thickness without unﬁnished wall

Thermal resistance R 0.75 m²K / W Thermal resistance value for SpeedUp Eco panel

Pipe spacing 125-250 mm EZ = 125; CZ = 250;

Requirements and specialities

Surface smoothness +/- 3 mm per 1 m. Observe building regulation requirements con-

cerning thermal insulation. Moisture condensation can occur and should be taken into

consideration when planning wall heating on outer walls or walls between heated and

unheated rooms.

Wall coverings

Fermacell/ﬁbre reinforced plasterboard: Thermal conductivity: 0.32 W/m²K; maximum

ﬂow temperature 55°C; form board butt joints as glued joints. Form wall attachment

with an elastic acrylic joint or joint ﬁller on divider.

Construction:

Refering to EN 1264

Construction number 611