28mm Wind Vanes
B28-SF-224
Please read these instructions fully before starting construction.
PVA or equivalent glue will be required to stick sections together.
Sand paper can be used to gently clean any joints.
A sharp modelling knife will be required to remove sections from the sprue. Please use knives with due care and
remember to cut away from yourself at all times.
During the construction of this model, you may find it convenient to use pegs / elastic bands to hold pieces in
place while you allow glue to dry.
Take the vanes, edge strips and the “Y” with the
rounded ends from the sprue.
Glue an edge strip to each vane.
Take the two connectors..
..and glue them into position on one of the vanes
(see pic).
Glue the other two vanes to the connectors as shown
above.
When attaching a “Y” piece, you will find it easier if
you insert a bit of the sprue into the gap. This also
gives more strength and prevents breakage.
Attach the “Y” with the rounded ends.
Take the other three edge strips (with fineals) and
the “Y” (with flat ends) from the sprue.
Glue the “Y” into position, then add the edge strips to
the outside edge of each vane.
Take the shaft and discs from the sprue.
Carefully slide one of the small discs along the shaft so
it meats the head (see pic). The hole in the disc is
slightly bigger than the shaft.
Slide the shaft through the holes in the centre of the
vanes.
NOTE: If you wish your vanes to be able to rotate, do
not glue this in place.
Slide the other small disc onto the shaft and upto the
base of the vanes. Again do not glue this to the vanes if
you wish them to rotate.
Glue the four medium dicsc and two larger discs into
positon.
Once the glue holding the discs has dried, cut off any
excess shaft so it is flush with the base.
The finished model.
-
1
-
2
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
Related papers
-
BLOTZ B15-SR-002 Assembly Instructions
-
BLOTZ B20_SR_002 Assembly Instructions
-
BLOTZ BH0-ME-110 Assembly Instructions
-
BLOTZ B15-ME-108 Assembly Instructions
-
BLOTZ B28-ME-106 Assembly Instructions
-
BLOTZ B10-ME-210 Assembly Instructions
-
BLOTZ B20_ME_204 Assembly Instructions
-
BLOTZ B20_ME_201 Assembly Instructions
-
BLOTZ B28-ST-107 Assembly Instructions
-
BLOTZ B28-OW-116 Assembly Instructions
