2. BLOTZ
  3. B15-ME-108

BLOTZ B15-ME-108 Assembly Instructions

  • Hello! I've reviewed the instructions for the 15mm Short Wall - Door Desert Fort model kit from BLOTZ. This document provides a step by step guide on how to assemble the laser-cut components into a small fort wall with an optional door. I'm ready to answer any questions you have about the assembly process, materials, or features of this model.
  • What type of glue is required for assembly?
    Is sanding required?
    What kind of tool is required to remove the pieces?
15mm Desert Fort – Short Wall - Door
B15-ME-108
Please read these instructions fully before starting construction.
PVA or equivalent glue will be required to stick sections together.
Sand paper can be used to gently clean any joints.
A sharp modelling knife will be required to remove sections from the sprue. Please use knives with due care and remember
to cut away from yourself at all times.
During the construction of this model, you may find it convenient to use pegs / elastic bands to hold pieces in place while
you allow glue to dry.
Take the pieces shown above from the sprue.
Attach the internal supports to the back of the rear
wall as shown above.
Turn the “roof” upside down and attach the other
pieces to it as shown.
[Optional] Glue the door behind the doorway.
Add the front wall.
Attach the base, gently slotting each lug into the
associated hole.
The finished model.
/