10mm Ancient City Wall – 90 Degree Internal Corner
B10-ME-210
Please read these instructions fully before starting construction.
PVA or equivalent glue will be required to stick sections together.
Sand paper can be used to gently clean any joints.
A sharp modelling knife will be required to remove sections from the sprue. Please use knives with due care and
remember to cut away from yourself at all times.
During the construction of this model, you may find it convenient to use pegs / elastic bands to hold pieces in place
while you allow glue to dry.
Take the pieces shown above from the sprue.
Glue them together as shown.
Also grab the two rear wall pieces.
Glue them together.
Then add them to the base.
Add the walkway.
The front wall pieces and strips.
Glue the left-hand wall pieces into place.
Add the right-hand wall pieces.
Then glue the strips into position.
/
