2. BLOTZ
  3. B28-ME-106

BLOTZ B28-ME-106 Assembly Instructions

  • Hello! I've reviewed the instructions for the 28mm Internal Corner Wall model. This document guides you through the assembly process, including how to attach the walls, supports, connectors, walkway, door and more. I'm ready to answer your questions about building this model.
  • What type of glue should I use?
    Do I need any special tools?
    Can I use pegs or elastic bands during construction?
28mm Desert Fort – Internal Corner Wall
B28-ME-106
Please read these instructions fully before starting construction.
PVA or equivalent glue will be required to stick sections together.
Sand paper can be used to gently clean any joints.
A sharp modelling knife will be required to remove sections from the sprue. Please use knives with due care and remember
to cut away from yourself at all times.
During the construction of this model, you may find it convenient to use pegs / elastic bands to hold pieces in place while
you allow glue to dry.
Remove the pieces shown above from the sprue.
Add the walls and internal supports (see pic).
Add the connector pieces.
[Optional] Glue the door behind the doorway.
Attach the walkway, gently inserting each lug into
the associated hole.
Add the right hand wall section….
..then the left-hand one.
The finished model.
/