28mm Fountain
B28-ST-107
Please read these instructions fully before starting construction.
PVA or equivalent glue will be required to stick sections together.
Sand paper can be used to gently clean any joints.
A sharp modelling knife will be required to remove sections from the sprue. Please use knives with due care and
remember to cut away from yourself at all times.
During the construction of this model, you may find it convenient to use pegs / elastic bands to hold pieces in place while
you allow glue to dry.
Fountain (B28-ST-107)
Remove the two base pieces from the sprue.
Glue them together using the guidelines to align then
correctly.
Glue the four rings together, aligning the scored lines.
Then attach them to the base as shown.
Glue two semi-circular cap-stone pices on top.
Next remove the ten large solid disks and the support post
from the sprue.
Glue the support post to the base (you may find it easier to
glue a small piece of scrap to the underide of the hole first.)
Glue the ten discs onto the pole, so they form a smooth
column.
Carefully lining up the scalloped pieces, glue these to the top
of the column.
Then glue the smaller discs into place.
The final two discs have circular holes in their centre. The
wider disc goes on top of the smaller disc (see right)
The finished Fountain.
/
