2. BLOTZ
  3. B20_ME_204

BLOTZ B20_ME_204, B20-ME-204, B28-ME-204 Assembly Instructions

  • Hello! I have reviewed the instructions for the BLOTZ City Wall Short Wall - Gate model. This document provides detailed steps on assembling the model, including gluing connectors, supports, and the gate section. It also specifies the required tools and materials. I'm ready to answer any questions you have about this kit.
  • What type of glue is required for assembly?
    What tool is needed to remove the pieces from the sprue?
    Are there different sizes for this kit?
20mm / 28mm Ancient City Walls – Short Wall - Gate
B20-ME-204 / B28-ME-204
Please read these instructions fully before starting construction.
PVA or equivalent glue will be required to stick sections together.
Sand paper can be used to gently clean any joints.
A sharp modelling knife will be required to remove sections from the sprue. Please use knives with due care and remember
to cut away from yourself at all times.
During the construction of this model, you may find it convenient to use pegs / elastic bands to hold pieces in place while
you allow glue to dry.
The images here show the 20mm version of this kit, but the 28mm version is constructed in exactly the same way.
Remove the pieces shown above from the sprue.
Glue the connectors to the main supports – the
connectors without end tabs being the ones
attached to the stone etched wall.
Attach these to the base.
Take these pieces.
Glue the roof and support together then glue it to
the model – after slotting the gates into position.
Add the central support.
Attach the rear wall.
Followed by the walkway.
The end brace pieces.
Glue these into place.
Add the front lower wall and crenellated piece.
Finally add the long strip.
/