2. Q-tran
  3. Q-TRAN TRE3 Three Sided Lens LED Aluminum Extrusion
Q-TRAN TRE3 Three Sided Lens LED Aluminum Extrusion

Q-tran Q-TRAN TRE3 Three Sided Lens LED Aluminum Extrusion, TRE3 Three Sided Lens LED Aluminum Extrusion Installation guide

  • Hello! I've reviewed the installation instructions for the Q-Tran Extrusion TRE3. This document details the mounting process using standard grid clips, the wire way specifics with wet-rated wire, and the proper placement of the T-Bar clips. I'm ready to answer your questions about the installation and setup of this product.
  • How many clips are required for mounting the extrusion?
    What type of wire is compatible with the wire way?
    Where should the T-Bar clips be placed?
© 2022 Q-Tran Inc. All rights reserved | 155 Hill St. Milford, CT 06460 | 203-367-8777 | [email protected] | www.q-tran.com Specification subject to change. Rev-02-22-22
INSTALLATION EXTRUSION - TRE3
NOTES:
• Field modifications must comply with Q-Tran’s installation methods otherwise warranty is null and void
Mounting Wire Way
Plastic T-Bar Clip
(PLC-01)
Mounting Clip
1.00”
.50”
.10”
NOTE
: Standard 1”
(15/16)
grid Clips for drop ceiling
2 clips provided per first 12”, 1 clip provided per additional foot
Cip on the T-BAR clips 4” inward from each end, and then 12” apart for the full length
To utilize the TRE 3’s wire way, pull the wire and insert the TBC-TRE3 clip onto the
bottom track to hold the wire down
NOTE: Wireway only works with our outdoor WET RATED wire
3.
1. 4"
4"
12"
2.
Remove protective film
/