2. BLOTZ
  3. B28-RU-010

BLOTZ B28-RU-010 Assembly Instructions

  • Hello! I've reviewed the instructions for the Blotz Ruin B28-RU-010 model. This document provides step-by-step instructions for assembling the 28mm scale ruin, including details on gluing wall sections, attaching the walkway and supports, as well as adding the finishing touches with brackets and rails, and the use of PVA glue, modeling knife, sandpaper is also described. I'm ready to answer your questions about the assembly process or any other aspect of this model.
  • What type of glue is needed for assembly?
    What tool is needed to remove parts from the sprue?
    What can be used to hold pieces together while the glue dries?
    Where can I find a full-colour copy of the instructions?
28mm Ruins #10
B28-RU-010
Please read these instructions fully before starting construction.
PVA or equivalent glue will be required to stick sections together.
Sand paper can be used to gently clean any joints.
A sharp modelling knife will be required to remove sections from the sprue. Please use knives with due care and remember
to cut away from yourself at all times.
During the construction of this model, you may find it convenient to use pegs / elastic bands to hold pieces in place while
you allow glue to dry.
A full-colour copy of these instructions can be found on our website: www.blotz.co.uk
Ruins #10 (B28-RU-010)
Remove the two wall sections from the sprue and glue
them together back to back so the edges of the
stonework line up.
Then remove the walkway from the sprue.
Glue the walkway to the wall using the lugs/holes
provided.
Each of the supports is formed from the pieces
shown.
Glue the small sections either side of the main support
so the thick ends line up.
Then glue them to the walkway.
Attach the base, aligning each peg with the holes
provided.
Attach the four brackets – the actual positions are
up to you.
Add the balcony rail.
Then the two handrails.
The finished ruin
/