2. BLOTZ
  3. B28-RU-003

BLOTZ B28-RU-003 Assembly Instructions

  • Hello! I've reviewed the instructions for assembling the Ruins B28-RU-003 model. This document details how to construct a 28mm scale ruin using glue and a modeling knife. It includes steps for joining wall sections and attaching them to the base. I'm ready to answer any questions you have about the assembly process or the required materials.
  • What type of glue is required?
    What tool is needed to remove sections from the sprue?
    What can be used to hold pieces together while the glue is drying?
28mm Ruins #3
B28-RU-003
Please read these instructions fully before starting construction.
PVA or equivalent glue will be required to stick sections together.
Sand paper can be used to gently clean any joints.
A sharp modelling knife will be required to remove sections from the sprue. Please use knives with due care and remember
to cut away from yourself at all times.
During the construction of this model, you may find it convenient to use pegs / elastic bands to hold pieces in place while
you allow glue to dry.
A full-colour copy of these instructions can be found on our website: www.blotz.co.uk
Ruins #3 (B28-RU-003)
Remove the two long wall sections from the sprue and
glue them together back to back so the edges of the
stonework line up.
Do the same with the two short wall sections.
You will end up with the two walls as shown above.
Note the lugs on the bottom do not line up.
Glue the walls together and slot them into the base.
/