1
Instruction
Danfoss Heating VIEUA102 Heating Solutions
Installation of SpeedUp Eco Wall Heating in wet systems
1 2
Attach the perimeter insulation by stapling it into place. To attach the individual system panels apply adhesive grout or tile adhesive
using the comb spatula.
3 4
Start with header/blank panels according to the lay-out drawing. The pre-formed cutting edges mean that the system elements are easy
to shorten using the circular hand saw/jig saw. Fill the boundary and
electrical areas with blank panels.
5 6
Mark individual pipe channels and cut out using the rotary cutter. Drill at least 8 holes for wall dowels (70 mm) per m
2
and attach dowel
bottom section.
Produced by Danfoss A/S © 06/2010
VIEUA102
7 8
Press the composite pipe into the pipe channels in a wide arc from bot-
tom to top. See distributor for connection.
Attach wall heating metalgrid from top to bottom, lightly tensioned and
with 10 cm overlap, using the dowel upper section.
9 10
Before applying the plaster carry out the required pressure test to at
least 6 bar, according to the test report.
The single 15 mm thick layer of plaster can be smoothed or matted as
required.
Instruction Installation of SpeedUp Wall Heating in wet systems
/