2. Danfoss
  3. SpeedUp Wall Heating in Wet Systems
SpeedUp Wall Heating in Wet Systems

Danfoss SpeedUp Wall Heating in Wet Systems Installation guide

  • Hello! I am an AI chatbot trained to assist you with the Danfoss SpeedUp Wall Heating in Wet Systems Installation guide. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!
1 Installation of SpeedUp Wall Heating in Wet Systems
Fig. 1: Attach the perimeter insulation using a stapler. Fig. 2: Start with header and blank panels according to layout
plan. Attach the individual panels horizontally to the wall using
material resistant adhesive (PU foam), supply should enter at
the bottom.
Fig. 3: The pre-formed break points mean that the system
elements can easily be shortened longitudinally and laterally.
Fig. 4: Fill boundary and electrical areas with blank panels.
Fig. 5: Individual pipe channels can be cut out with the hot
wire cutter, ensuring that a wide arc is used.
Fig. 6: Drill at least 8 holes for wall dowels (70 mm) per m² and
attach bottom section of dowel.
Installation Guide
SpeedUp Wall Heating in Wet Systems
Danfoss Heating Solutions VIETC202
1
Fig. 7: Starting from the supply point at the bottom, press the
composite pipe into the channels.
Fig. 8: Attach reinforcement grid from top to bottom, lightly
tensioned and with 10 cm overlap, using the dowel upper
section.
Fig. 9: Before applying the plaster carry out the required
pressure test to at least 6 bar, according to the test report.
Fig. 10: The 15 mm thick single plaster layer can be smoothed
or matted as required.
Installation Guide
SpeedUp Wall Heating in Wet Systems
Danfoss A/S
Heating Solutions
Haarupvaenget 11
8600 Silkeborg
Denmark
Phone:+45 7488 8000
Fax: +45 7488 8100
Email: [email protected]
www.heating.danfoss.com
Danfoss can accept no responsibility for possible errors in catalogues, brochures and other printed material. Danfoss reserves the right to alter its products without notice. This also applies to products
already on order provided that such alterations can be made without subsequential changes being necessary in specifications already agreed. All trademarks in this material are property of the respective
companies. Danfoss and the Danfoss logotype are trademarks of Danfoss A/S. All rights reserved.
VIETC202 Produced by Danfoss Heating Solutions © 11/2010
/