2. Q-tran
  3. Q-TRAN Micro 5 Series Mini LED Fixture
Q-TRAN Micro 5 Series Mini LED Fixture

Q-tran Q-TRAN Micro 5 Series Mini LED Fixture, Micro 5 Series Mini LED Fixture Installation guide

  • Hello! I have reviewed the installation instructions for the Q-Tran ALTA - MICRO 5 SERIES LED Light and its mounting accessories. The document covers various installation methods like screw mounting, millwork mounting, silicone and VHB mounting including the use of clips. I'm ready to assist you with any questions you may have about these instructions or the installation process.
  • How many clips are provided for mounting?
    What type of screw is used for magnet mounting?
    Can silicone mounting be used in submersible applications?
© 2022 Q-Tran Inc. All rights reserved | 155 Hill St. Milford, CT 06460 | 203-367-8777 | [email protected] | www.q-tran.com Specification subject to change. Rev-03-31-22
INSTALLATION ALTA - MICRO 5 SERIES
Mounting
NOTE: 2 clips provided for 4’ or less;
4 clips provided for greater than 4’
NOTES:
• Field modifications must comply with Q-Tran’s installation methods otherwise warranty is null and void
Stainless Steel Clip
(SST-08)
3.
1.
24" -
30"
2.
3.
2.
20
MINS
1.
832
NOTE:
Apply silicone in a well ventilated area. 832 Silicone is sold with caulking gun. Do not use in any submersible applications.
832 Silicone Mounting
Screw Mounting
Millwork Mounting - SST Clip
#4x5/8"
Flat head screw
.21
"
.625"
.21
"
.52"
1.25"
VHB Mounting
3.
2.
1.
3.
1.
.56
.50
2.
Section View
© 2022 Q-Tran Inc. All rights reserved | 155 Hill St. Milford, CT 06460 | 203-367-8777 | [email protected] | www.q-tran.com Specification subject to change. Rev-03-31-22
INSTALLATION ALTA - MICRO 5 SERIES
Mounting
Magnet Clip
(MG-03)
One magnet clip per foot
Magnet Mount Accessory
(MMA-03)
96" lengths
(Sold separately)
0.95"
0.08
"
0.28"
3.
2.
NOTE:
The magnet clips should be offset to the flat heads used to secure the bracket, to maximize magnetic connection
.
NOTE:
For millwork with magnets, adhesive must be used to complete install.
Using the #6 Flat head screws, mount screws into the magnet bracket
through the drilled holes.
Adjust magnet location by applying rubber stoppers. Connect the assembled fixture to the magnet bracket, the install should
match the section view.
Magnet Mounting
Millwork Mounting - Magnet
Section View
#6x5/8"
Flat head screw
.26
"
.625"
3.
1.
.46
.50
2.
Section View
.44”
.07”
8”
/