2. Computers & electronics
  3. Computer cables
  4. Signal cables
  5. Arducam
  6. V1

Arducam V1 User guide

  • Hello! I've reviewed the user manual for the Arducam Cable Extension Kit V1/V2/HQ/16MP-AF. This document describes how to verify your camera module before using the extension cable with Raspberry Pi. I am ready to assist with any questions you may have about its setup, compatibility, or features.
  • What camera modules are compatible with this cable extension kit?
    Do I need to verify my camera module before using the cable extension kit?
    Which Raspberry Pi OS versions are supported?
    What terminals commands I can use to verify camera module?
www.arducam.com
Cable Eension Kit
for Camera Module V1/V2/HQ/16MP-AF
Getting Started
IPublished in January 2022
by ARDUCAM TECHNOLOGY CO., LIMITED
Things to Do Before Assembling the Cable Extension Kit



1. Connect the camera directly to your Raspberry Pi.
2. Open up a terminal, enter the llowing commands:




 
If a live preview window pops up, you are good to go with the kit. If not, contact the company
where you got your camera module r help.

ABefore u Start



 
1.
Open a terminal
2.
Run sudo raspi-config
3.
Navigate to Advanced Options
4.
Enable Glamor graphic acceleration
5.
Reboot your Pi
 

1 Cable Extension Kit r Camera Module V1 N2/HQ/16MP-AF
/