Arducam B0399B0283 User guide

Brand: Arducam

Model: B0399B0283

Type: User guide

for Raspberry Pi Cameras

Published in June 2022

by ARDUCAM TECHNOLOGY CO., LIMITED

Getting Started

SKUB0399B0283

Pan-Tilt Kit

Packing List

Installation

The kit is compatible with the ocial camera module V1, V2, HQ and Arducam Pi

cameras with same form factors.

Keep the servo arms in the original position so no further calibration is required.

Turn o your Raspberry Pi and disconnect the power supply.

1. Install the controller board.

2. Install the pre-assembled pan servo.

×1

×2

×1

×1 ×1

×4 ×1

×1 ×1

×5

×10

Pan-Tilt Kit for Raspberry Pi Cameras

1

M2×4mm

M2×6mm

M2×6mm

M2×6mm

Pan-Tilt Kit for Raspberry Pi Cameras

2

Installation

3. Install the pre-assembled tilt servo.

4. Connect the servos to the controller board.

5. Connect the pan-tilt kit to your Raspberry Pi.

Follow the servo motors' wire colors but not the jumper wires'. The colors of the jumper

wires are used to distinguish between each other only and do not need to be matched

in real wire connection to the Raspberry Pi.

M2×6mm

W

R

BW

R

B

L

L

R

R

Top viewBack view

NOTE: Pls make sure the wires to

the servo are correctly connected.

Pan-Tilt Kit for Raspberry Pi Cameras

3

Operating the Pan-Tilt Kit

1. Clone demo code

git clone hps://github.com/ArduCAM/PCA9685.git

2. Enter the target directory

cd PCA9685/

3. Compile the code

make

4. Run the demo

sudo ./RunServoDem

Use the arrow keys on the keyboard to control the camera pan and

tilt direction.

www.arducam.com

Raspberry Pi and the Raspberry Pi logo are trademarks of the Raspberry Pi Foundation

1
2
3
4
5

Arducam B0399B0283 User guide

Brand: Arducam

Model: B0399B0283

Type: User guide

Related papers

Other documents