Danfoss SpeedUp Wall Heating - Dry construction User guide

Application Sheet

SpeedUp Wall Heating

Dry construction with wood battens

Fibre reinforced plasterboard

1 Dry walling screws

2 Wood battens, 30 mm

3 SpeedUp panel, 30 mm

4 Danfoss composite pipe 16 x 2 mm

5 Fibre reinforced plasterboard, 12.5 mm

Technical Data Drywall construction with wood battens

Wall Covering 12.5 mm Fibre reinforced plasterboard or similar

Constructional thickness 42.5 mm Dimensions without unﬁnished wall

Thermal resistance R 0.86 m²K / W Thermal resistance value for SpeedUp panel

Pipe spacing 125-250 mm EZ = 125; CZ = 250;

Requirements and specialities

Surface smoothness +/- 3 mm per 1 m. Observe building regulation requirements con-

cerning thermal insulation. Moisture condensation can occur and should be taken into

consideration when planning wall heating on outer walls or walls between heated and

unheated rooms.

Wall coverings

Fermacell/ﬁbre reinforced plasterboard: 0.32 W/m²K; maximum ﬂow temperature: 55°C;

form board butt joints as glued joint. Form wall attachment with an elastic acrylic joint

or joint ﬁller on divider.

Construction:

Refering to EN 1264

Construction number 602