Dry Construction with Wood

Battens

1 Dry walling screws

2 Wood battens, 30 mm

3 SpeedUp Eco panel, 30 mm

4 Danfoss composite pipe 16 x 2 mm

5 Fibre reinforced plasterboard, 12.5 mm

Technical Data

Dry construction with wood battens and fibre

specialities

requirements concerning thermal insulation. Moisture condensation can occur

and should be taken into consideration when planning wall heating on outer

walls and walls between heated and unheated rooms.

Wall coverings Fermacell/fibre reinforced plasterboard: Thermal conductivity 0.32 W/m²K;

maximum flow temperature 55°C; form board butt joint as glued joint. Form

wall attachment with an elastic acrylic joint or joint filler on divider.

Construction Referring to EN 1264.

Construction number 612

Application Sheet

SpeedUp Eco Wall Heating - Dry Construction with

8600 Silkeborg

Denmark

Phone:+45 7488 8000

Fax: +45 7488 8100

Email: [email protected]

www.heating.danfoss.com

Danfoss can accept no responsibility for possible errors in catalogues, brochures and other printed material. Danfoss reserves the right to alter its products without notice. This also applies to products

already on order provided that such alterations can be made without subsequential changes being necessary in specifications already agreed. All trademarks in this material are property of the respective

companies. Danfoss and the Danfoss logotype are trademarks of Danfoss A/S. All rights reserved.

2 VAEUN202 © Danfoss 03/2011 Danfoss Heating Solutions