2. Computers & electronics
  3. Computer cables
  4. Signal cables
  5. Focal Point
  6. Seem 4 LED Pop-Down Lens FSM4LS-PD

Focal Point Seem 4 LED Pop-Down Lens FSM4LS-PD, Seem 4 LED Direct Suspended / Surface Mount FSM4LS Installation guide

  • I've reviewed the Seem FSM4LS LED luminaire installation instructions. This document provides detailed guidance for proper installation, including cable grippers, reflector attachments, and lens options. I am ready to answer your questions about the installation process, components, or any other topic that is covered in this document.
  • Who should install the luminaires?
    What should be done before installation?
    How many cable grippers are needed for an individual unit?
©2023 Focal Point, LLC | 4141 S. Pulaski Rd., Chicago, IL 60632 | www.focalpointlights.com/reference
1 of 4
IS0518 REV. M
Seem® 4 LED
Suspended | FSM4LS
• Luminaires must be installed by a qualified
electrician (check with local and national
codes for proper installation).
• To prevent electrical shock, disconnect
electrical supply before installation or
servicing.
• Contractor is responsible for adequately
reinforcing walls and/or ceilings to support
fixture weight.
• Focal Point, LLC accepts no responsibility
for inadequately reinforced walls and/or
ceilings.
• The information contained in this drawing
is the sole property of Focal Point, LLC. Any
reproduction in part or whole without the
written permission of Focal Point, LLC is
prohibited.
POWER OFF
POWER ON
ATTENTION
SEE ADDITIONAL
INSTRUCTIONS
32
BEFORE YOU BEGIN COMPONENT KEY
INSTRUCTION KEY
FOCAL POINT
U - Individual
S - Start of run
I - Intermediate
E - End of run
Flush Lens
Joiner Bracket
(11849)
Joiner
Bracket
(11920)
Cable Gripper (73014)
& Nylon Nut (70044)
Joiner Pin
(W5687)
Reflector (70008)
(6-32 X 5/16 Pan-head
machine screw)
Pop-Down Lens
(indivudual housings
only up to 8’)
SHIPPED IN HARDWARE BAG
PARTS SHIPPED INSTALLED
TWO CABLE GRIPPERS EACH FOR
INDIVIDUAL AND START, ONE FOR
INTERMEDIATE AND END HOUSINGS.
FOLLOW FOCAL POINT
INSTRUCTIONS FOR UNIVERSAL
SUSPENSION SYSTEM ASSEMBLY.
SEE IS
1
INDIVIDUAL INSALLATIONS FOLLOW STEPS , , , ,  & 
2 of 4
IS0518 REV. M ©2023 Focal Point, LLC | 4141 S. Pulaski Rd., Chicago, IL 60632 | www.focalpointlights.com/reference
9
65
711
8
4
AVOID ALL CONTACT WITH LED SURFACE,
LEDs ARE EASILY DAMAGED!
10 11
11 12
MAKE ELECTRICAL CONNECTION
14
13 SECURE REFLECTORS TO HOUSING
 SCREWS PER REFLECTOR
AVOID ALL CONTACT WITH LED SURFACE,
LEDs ARE EASILY DAMAGED!
FLUSH LENS
3 of 4
IS0518 REV. M ©2023 Focal Point, LLC | 4141 S. Pulaski Rd., Chicago, IL 60632 | www.focalpointlights.com/reference
15
11
14
USE IMPRINT ON .” POPDOWN LENSES
TO ENSURE ALL LENSES ARE INSTALLED
FACING THE SAME DIRECTION
POPDOWN LENS
DRIVER SERVICE
11
11111
32 SECURE REFLECTORS TO HOUSING
 SCREWS PER REFLECTOR
AVOID ALL CONTACT WITH LED SURFACE,
LEDs ARE EASILY DAMAGED!
EMERGENCY
SEE BATTERY MANUFACTURER
INSTRUCTIONS
emergency maximum mounting height:
19.00'
AVOID ALL CONTACT WITH LED SURFACE,
LEDs ARE EASILY DAMAGED!
ASYMMETRIC LENS
ASYMMETRIC LENS
DISTRIBUTION DIRECTION
ASYMMETRIC ROOM FILL
LENS DISTRIBUTION
DIRECTION
14 14
4 of 4
IS0518 REV. M ©2023 Focal Point, LLC | 4141 S. Pulaski Rd., Chicago, IL 60632 | www.focalpointlights.com/reference
ACUITY nLIGHT
123
5
4
1 2 3
4 5
SEGMENTED
NETWORK
CABLE
CONNECTION
POINTS FOR
SEGMENTED
NETWORK CABLE
SEE MANUFACTURER’S
INSTRUCTIONS
WATTSTOPPER
HUBBELL NX
1
CONNECT
CAT CABLE
BY OTHERS
CONNECT
CAT CABLE
BY OTHERS
CAT CABLE
BY OTHERS
/