Focal Point Seem 4 LED Direct/Indirect FSM4BW Installation guide

Brand: Focal Point

Model: Seem 4 LED Direct/Indirect FSM4BW

Type: Installation guide

IS0704 Rev. B 2023 ©Focal Point, LLC 4141 S. Pulaski Rd., Chicago, IL 60632 | www.focalpointlights.com 1 of 3

seem™ 4 led direct/indirect wall mount

FSM4BW

focal point

U -

individUal

S -

Start of rUn

i -

intermediate

e -

end of rUn

individUal

(Start of rUn)

Luminaires must be installed by a qualied electrician (check with local and national codes for proper installation).

To prevent electrical shock, disconnect electrical supply before installation or servicing.

configUrationS are rUn Specific, pleaSe conSUlt factory drawingS before beginning inStallation.

key

See additional

inStrUctionS

power off power on attention

intermediate

(end of rUn)

2' housing 3' & 6' housings

LOCATE J-BOX CENTER & INSTALL (J-BOX BY OTHERS. 4"x2" handy box.)

12.10" 18.10"

4', 7' & 8' housings 5' housing

luminaire outline

24.10" 30.10"

2.62"

4.52"

2.62"

individUal inStallationS follow StepS 1-3, 5 & 11

Flush Lens Down

Flush Lens Up Pop-Up Lens

0.5" Pop-Down Flush Lens Down

Pop-Up Lens

(FASTENERS BY OTHERS)

partS liStS

joiner

(72010)

(6-32 X 5/16 pan-Head

macHine Screw)

SHipped inStalled

joiner aSSembly

(a40688)

top bracket

joiner

(a38740-01)

bottom bracket

joiner

(a42759-01)

117

23 INSTALL REMAINING RAILS.

REMOVE END SECTION FROM

LAST RAIL IN RUN.

(FASTENERS BY OTHERS)

C116

AVOID ALL CONTACT WITH LED SURFACE,

LEDS ARE EASILY DAMAGED!

IS0704 Rev. B 2023 ©Focal Point, LLC 4141 S. Pulaski Rd., Chicago, IL 60632 | www.focalpointlights.com 2 of 3

Luminaires must be installed by a qualied electrician (check with local and national codes for proper installation).

To prevent electrical shock, disconnect electrical supply before installation or servicing.

114

make electrical connections

WIRE NUTS FOR

DIMMING WIRES

BY OTHERS

10 X2

11 X2

8119

driver Service

AVOID ALL CONTACT WITH LED SURFACE,

LEDS ARE EASILY DAMAGED!

111

AVOID ALL CONTACT WITH LED SURFACE,

LEDS ARE EASILY DAMAGED!

Contractor is responsible for adequately reinforcing walls and/or ceilings to support luminaire weight. Focal Point, LLC accepts no responsibility for inadequately reinforced walls

and/or ceilings. The information contained in this drawing is the sole property of Focal Point, LLC. Any reproduction in part or whole without the written permission of Focal Point, LLC

is prohibited.

113

EMERGENCY

SEE BATTERY MANUFACTURER

INSTRUCTIONS

emergency battery

maXimUm moUnting HeigHt: 17.75’

ASYMMETRIC LENS

DISTRIBUTION DIRECTION

ASYMMETRIC ROOM FILL

LENS DISTRIBUTION

DIRECTION