Focal Point Seem 4 LED Direct/Indirect FSM4BS Installation guide

Brand: Focal Point

Model: Seem 4 LED Direct/Indirect FSM4BS

Type: Installation guide

IS0703 Rev. D 2023 ©Focal Point, LLC 4141 S. Pulaski Rd., Chicago, IL 60632 | www.focalpointlights.com 1 of 3

seem™ 4 led direct/indirect suspended

FSM4BS

focal point

U -

individUal

S -

Start of rUn

i -

intermediate

e -

end of rUn

Luminaires must be installed by a qualied electrician (check with local and national codes for proper installation).

To prevent electrical shock, disconnect electrical supply before installation or servicing.

configUrationS are rUn Specific, pleaSe conSUlt factory drawingS before beginning inStallation.

individUal

inSallationS follow

StepS 1-3 , 10 & 11

key

See additional

inStrUctionS

power off

power on

attention

cable gripper

(73008)

FOLLOW FOCAL POINT

INSTRUCTIONS FOR

UNIVERSAL SUSPENSION

SYSTEM ASSEMBLY.

SEE IS0166

111

114

partS liStS

joiner

(72010)

(6-32 X 5/16 pan-Head

macHine Screw)

SHipped inStalled

joiner aSSembly

(a40688)

top bracket

joiner

(a38740)

Flush Lens Do

wn 0.5" Pop-Down

Flush Lens Up Batwing Batwing

Batwing

Flush Lens

1.5" Pop-Down

Pop-Up Lens Pop-Up Lens

Flush Lens 0.5" Pop-Down

Flush Lens Down 0.5" Pop-Down

Flush Lens Up Batwing Batwing Batwing

Flush Lens

1.5" Pop-Down

Pop-Up Lens Pop-Up Lens

Flush Lens 0.5" Pop-Down

bottom bracket

joiner

(a42759-01)

112

AVOID ALL CONTACT WITH LED SURFACE,

LEDS ARE EASILY DAMAGED!

IS0703 Rev. D 2023 ©Focal Point, LLC 4141 S. Pulaski Rd., Chicago, IL 60632 | www.focalpointlights.com 2 of 3

Luminaires must be installed by a qualied electrician (check with local and national codes for proper installation).

To prevent electrical shock, disconnect electrical supply before installation or servicing.

8119

117

11 X2

115

make electrical connectionS

WIRE NUTS FOR DIMMING

WIRES BY OTHERS

ASYMMETRIC LENS

DISTRIBUTION DIRECTION

ASYMMETRIC ROOM FILL

LENS DISTRIBUTION

DIRECTION

12 12

Contractor is responsible for adequately reinforcing walls and/or ceilings to support luminaire weight. Focal Point, LLC accepts no responsibility for inadequately reinforced walls

and/or ceilings. The information contained in this drawing is the sole property of Focal Point, LLC. Any reproduction in part or whole without the written permission of Focal Point, LLC

is prohibited.

EMERGENCY

SEE BATTERY MANUFACTURER

INSTRUCTIONS

emergency battery

maXimUm moUnting HeigHt: 15.50’

driver Service

AVOID ALL CONTACT WITH LED SURFACE,

LEDS ARE EASILY DAMAGED!

111

AVOID ALL CONTACT WITH LED SURFACE,

LEDS ARE EASILY DAMAGED!