2. BLOTZ
  3. B28-SFC-012

BLOTZ B28-SFC-012 Assembly Instructions

  • I have reviewed the instructions for the Ladder B28-SFC-012. This document details the steps required to assemble a two-level ladder using laser-cut wooden pieces. It covers the use of glue, sandpaper, and a modelling knife, as well as techniques for holding parts during assembly. I'm ready to answer your questions about the assembly process.
  • What kind of glue is needed for assembly?
    What tool is needed to remove sections from the sprue?
    Can sandpaper be used during assembly?
    Are there any specific recommendations for holding pieces together while the glue dries?
28mm Ladder (2 level)
B28-SFC-012
Please read these instructions fully before starting construction.
PVA or equivalent glue will be required to stick sections together.
Sand paper can be used to gently clean any joints.
A sharp modelling knife will be required to remove sections from the sprue. Please use knives with due care and
remember to cut away from yourself at all times.
During the construction of this model, you may find it convenient to use pegs / elastic bands to hold pieces in
place while you allow glue to dry.
The ladder is formed from the pieces shown
above. Glue the ladder to the edge pieces, then
glue the foot into place.
The connector and handrail.
Glue the connector to the notches in the ladder,
then glue the handrail into position.
The finished model.
/