2. Coats
  3. Kit 8183061, Duckhead Mount/Demount Tool

Coats Kit 8183061, Duckhead Mount/Demount Tool Operating instructions

  • Hello! I've reviewed the provided instructions for the COATS Mount/Demount Tool Upgrade Kit 8183061. This document outlines how to adjust the tool head lift and lock tightness, including information about using metal and plastic duckheads. I'm ready to answer your questions about the tool and its operation.
  • What is the purpose of shoulder screw (ref.1)?
    What is the procedure for adjusting lock tightness?
    When should shim 85606345 be used?
8183063 05 06/2017 © COPYRIGHT 1995 HENNESSY INDUSTRIES AND COATS ALL RIGHTS RESERVED PRINTED IN U.S.A.
Duckhead™ Mount/Demount Tool
Upgrade Kit 8183061
COATS, Inc. • Hennessy Industries • 1601 J. P. Hennessy Drive, LaVergne, TN 37086
(800) 688-6359 • (615) 641-7533 • (615) 641-5104 FAX www.coatsgarage.com
Note:
These instructions are to be used
on tapered vertical slide shafts only.
Nylon mount/demount tools are not cov-
ered under regular warranty as these items
are expendable.
Mount/Demont Tool Head Adjustment
To Adjust Tool Head Lift
Shoulder screw (ref.1) sets the tool head lift for
metal duckheads – no adjustment required. Place
shim 85606345 on screw if using a plastic duck-
head.
To Adjust Lock Tightness
With lock handle unlocked, loosen jam nut (ref. 2)
and adjust pin (ref. 3) until a slight firmness is
obtained, then tighten jam nut and check. Also
recheck tool head lift at this time.
/