2. Coats
  3. 85612848 Sonar

Coats 85612848 Sonar Operating instructions

  • Hello! I've reviewed the Sonar Installation Instruction for the COATS Series 85612849. This document provides step-by-step instructions on how to install the sonar unit on a wheel balancer, including mounting the bracket, attaching the sonar, and routing the cable. It also emphasizes the importance of disconnecting power before any maintenance. I am ready to assist you with any questions about the installation process or device.
  • What should I do before starting the installation?
    What is the first step for the installation?
    What do i have to do after routing cable?
COATS, Inc. • Hennessy Industries • 1601 J.P. Hennessy Drive, LaVergne, TN 37086-3565
(800) 688-6359 • (615) 641-7533 • (615) 641-5104 FAX • www.ammcoats.com
85606872 00 07/10 © COPYRIGHT 2010 ALL RIGHTS RESERVED PRINTED IN U.S.A.
To avoid electrical shock, ALWAYS discon-
nect unit from electrical power before per-
forming any service or maintenance on the
components.
Instructions
1. Install hood assembly onto balancer If applicable.
2. Next, remove hood from the hood bar if applicable.
3. Uncoil the cable at back of balancer. if applicable.
4. Now slice an X in the end cap, if applicable.
5. Route cable
through hood bar
to sonar location if
applicable.
6. Remove sonar and bracket from template.
7. Install sonar bracket on hood bar with hardware
provided.
8. Mount bracket.
9. Mount sonar.
10. Attach cable to sonar.
11. Replace hood onto hood bar; aligning cable if
applicable.
Sonar Installation Instruction
For use with COATS Series Wheel Balancer
Sonar Service Kit 85612849
Slice End Cap
To Route Cable
Sonar
Cable
Sonar
Bracket
Mount
Sonar In
Bracket
Sonar
Location
Sonar
Align Cable
85612848 00 12/2022 © Copyright 2022 Hennessy Industries LLC All Rights Reserved.
/