Coats Kit 8183846, Mount/Demount Operating instructions

Mount/Demount Kit #8183846

for Rim Clamp Tire Changers

COATS, Inc. • Hennessy Industries • 1601 J.P. Hennessy Drive, LaVergne, TN 37086-3565

(800) 688-6359 • (615) 641-7533 • (615) 641-5104 FAX

Note:

There should be about 12-degrees of rota-

tional play of the plastic mount/demount head when

installed to allow the tool to self align when in use.

Item Part No. Description

1 8106302 3/8-16 Whiz Lock Screw

2 8182027 7 ga. x .406 x 1.28 OD Washer

3 8182960 Plastic Mount/Demount Head

4 85606345 Shim

These parts not supplied with kit, shown for ref-

erence only.

Mount/Demont Tool Head Adjustment

To Adjust Tool Head Lift

Shoulder screw (ref.1) sets the tool head lift for

metal duckheads – no adjustment required. Place

shim 85606345 on screw if using a plastic duck-

head.

To Adjust Lock Tightness

With lock handle unlocked, loosen jam nut (ref. 2)

and adjust pin (ref. 3) until a slight firmness is

obtained, then tighten jam nut and check. Also

recheck tool head lift at this time.