2. Coats
  3. Kit 85611611 Robo-Roller

Coats Kit 85611611 Robo-Roller, 85611612 00 Robo-Roller User manual

  • Hello! I have analyzed the document describing the COATS Service Kit 85611611, which includes the Extractor Tool 85611610 and Ring Plungers 85607804 for repairing the Duckhead Finger-Roller 85607802. The document provides step-by-step instructions for removing a broken Ring Plunger and installing a new one. I am ready to answer your questions about this procedure.
  • What is the purpose of this service kit?
    What tool is used to remove the broken Ring Plunger?
    How do you remove the broken Ring Plunger?
    How do you install new Ring Plunger?
85611612 00 10/19 © COPYRIGHT 2019 ALL RIGHTS RESERVED PRINTED IN U.S.A.
Robo-Roller Service Kit 85611611
Instructions
®
Hennessy Industries, Inc. • 1601 J.P. Hennessy Drive, LaVergne, TN 37086
(800) 688-6359 • (615) 641-7533 • (615) 641-5104 FAX • www.coatsgarage.com
Parts Identification
Qty. Description
1 #4 Extractor Tool (85611610)
5 Ring Plunger 3/8-16 (85607804)
Instructions
NOTE: This procedure should be followed to remove and replace a broken Ring Plunger (85607804) in a
Duckhead Finger-Roller (85607802).
1. While holding the Duckhead Finger-Roller as shown, insert the #4 Extractor Tool.
Hold the Duckhead Finger-Roller on a sturdy surface and tap the Extractor with a Hammer.
#4 Extractor
Tool
Broken
Ring Plunger
Duckhead
Finger-Roller
85611612 00 10/19 © COPYRIGHT 2019 ALL RIGHTS RESERVED PRINTED IN U.S.A.
2. Use a Tap Handle or Wrench to turn the Extractor Counter-Clockwise (CCW) to remove the
broken Ring Plunger.
3. Insert a new Ring Plunger (85607804) finger tight. Use a 3/8” Wrench to continue turning the
Ring Plunger until it stops against the Duckhead Finger-Roller as shown.
Tight against
the Duckhead
Finger-Roller
Tap Handle
Broken Ring
Plunger
/