2. Coats
  3. HTS Cable Replacement

Coats HTS Cable Replacement Operating instructions

  • Hello! I've reviewed the instructions for the COATS Cable Assembly replacement, specifically model 85611399. The document details how to correctly replace the cable assembly by inserting the cable, removing insulation, and attaching the valve stem puller. I'm here to help you with any questions you might have about this process.
  • How much insulation should be removed?
    What tool is used to tighten the set screw?
    How to ensure cable is securely fastened?
1. Slide the Cable end through the Inflator Nozzle hole where shown.
Use Wire Strippers to remove 5/8” (.625”) insulation.
2. Slide the Valve Stem Puller (85611399), on the Cable until it touches the insulation.
Use a 1/16” Allen Wrench to tighten the Set Screw securely.
3. While holding the Cable, pull on the Nozzle to ensure that it is securely fastened.
85611395 00 07/2018 © Copyright 2018 Hennessy Industries and COATS® All Rights Reserved. Printed in U.S.A.
Cable Assembly
Replacement Instructions
Hennessy Industries, Inc. • 1601 J.P. Hennessy Drive, LaVergne, TN 37086
(800) 688-6359 • (615) 641-7533 • (615) 641-5104 FAX • www.coatsgarage.com
.625”
/