Bauknecht DDLE 5790 IN Program Chart

Category
Cooker hoods
Type
Program Chart

Bauknecht DDLE 5790 IN is a versatile and powerful kitchen appliance that combines a cooker hood and an extractor fan into one sleek unit. With three speed settings, it effectively removes steam, fumes, and odors from your cooking, leaving your kitchen fresh and clean. The halogen bulbs provide bright illumination for your cooking surface, while the grease filters are easily removable for cleaning. Whether you're boiling, frying, or grilling, the Bauknecht DDLE 5790 IN is an essential tool for any modern kitchen.

Bauknecht DDLE 5790 IN is a versatile and powerful kitchen appliance that combines a cooker hood and an extractor fan into one sleek unit. With three speed settings, it effectively removes steam, fumes, and odors from your cooking, leaving your kitchen fresh and clean. The halogen bulbs provide bright illumination for your cooking surface, while the grease filters are easily removable for cleaning. Whether you're boiling, frying, or grilling, the Bauknecht DDLE 5790 IN is an essential tool for any modern kitchen.

5019 418 33036
DDLE 5790 -
DDXE 5790
INSTALLATIONSBLAD
Minsta tillåtna avstånd från olika typer av spisar: 50 cm (elektrisk spis), 75 cm
(gasspis, gasolspis och koleldad spis). Följ numreringen nedan för monteringen:
(1Ö2Ö3Ö.....). Slå inte på strömmen till fläktkåpan förrän installationen är helt
avslutad. Observera! Rökröret och rörklämmorna som krävs för installationen (15)
levereras inte tillsammans med fläktkåpan, utan måste köpas separat.
INSTALLASJONSVEILEDNING
Minimumsavstand til komfyrtopp: 50 cm (elektriske kokeplater), 75 cm (gass-,
parafin- eller kullkomfyr. Følg nummereringen ved montering (1Ö2Ö3Ö.....).
Apparatet må ikke tilkobles strømnettet før installasjonen er helt avsluttet. Merk!
Avtrekksrøret og klemmene (15) følger ikke med og må bestilles separat.
INSTALLATIONSVEJLEDNING
Minimumafstand fra kogezoner: 50 cm (elkogezoner), 75 cm (gas-, olie- eller
kulfyrede kogezoner. Ved montering skal man følge vejledningens
nummerrækkefølge (1Ö2Ö3Ö.....). Apparatet må ikke tilsluttes elforsyningen, før
installationen er fuldført. Advarsel! Aftræksrøret og spændebåndene (15) leveres
ikke med emhætten og skal købes separat.
ASENNUSOHJEET
Vähimmäisetäisyys liedestä: 50 cm (sähköliesi), 75 cm (kaasu-, öljy- tai hiililiedet).
Suorita kokoonpano numerojärjestyksessä (1Ö2Ö3Ö.....). Älä kytke liesituuletinta
sähköverkkoon ennen kuin kaikki asennusvaiheet on suoritettu. Huomaa!
Poistoputkea ja kiinnittimiä (15) ei toimiteta laitteen mukana, ne on hankittava
erikseen.
INSTALLATION SHEET
Minimum height above cooker: 50 cm (electric cookers), 75 cm (gas, gas oil or coal
cookers). To install, follow points (1Ö2Ö3Ö.....). Do not connect the appliance to the
electrical power supply until installation is completed. Warning! The exhaust pipe
and clamps (15) are not supplied and must be bought separately.
S
N
DK
FIN
GB
41833036.fm Page 1 Monday, October 18, 2004 5:40 PM
5019 418 33036
DDLE 5790 -
DDXE 5790
=
=
X
G
20b
20b
7-16
7-16
4
5
6
8
9
14
14
15
18
20a
20a
9
8
19
8
9
1
17
B
G
H
11
11
1
21
F
2
2
12
13
10
17
1
3
3
3
3
3
41833036.fm Page 2 Monday, October 18, 2004 5:40 PM
5019 418 33036
DDLE 5790 -
DDXE 5790
FINS N DK GB
Preliminary information for installing the hood:
Disconnect the power supply at the domestic main switch before carrying out electrical
connections.
1. Place the extraction unit on a flat surface and fit the bottom part of the hood on it (remove
the grease filter/s).
2. Carry out the electrical connections between the two parts.
3. Fix the hood to the extraction unit with 6 screws.
4. Using a pencil, draw the centre line on the wall up to the ceiling to facilitate installation
operations.
5. Attach the hole diagram to the wall: the vertical centre line printed on the hole diagram
must match the centre line drawn on the wall, and the lower edge of the hole diagram must
match the lower edge of the hood: remember that with installation completed the bottom
of the hood must be at least 50 cm above the cooktop in case of electric cookers and 75 cm
in case of gas or mixed cookers.
6. Place the support bracket on the hole diagram so that it matches the dashed rectangle, mark
the two external holes and drill, remove the hole diagram, insert 2 wall plugs and fix the
hood support bracket with two 5x45 mm screws.
7. Hook the hood to the bracket.
8. Adjust the distance between the hood and the wall.
9. Adjust the hood horizontally.
10.From the inside of the hood, mark the holes for fixing it.
11.Remove the hood from the bracket.
12.Drill on the mark (Ø 8 mm - see step 10).
13.Insert 1 wall plug.
14.Fit the flue support bracket G to the wall and against the ceiling, use the support bracket as
hole diagram (the small slot on the support must match the line drawn on the wall - step 4)
and mark 2 holes with the pencil, drill the holes (Ø 8 mm), and finally insert 2 plugs.
15.Fix the flue support bracket to the wall with two 5x45 mm screws.
16.Hook the hood to the bottom bracket.
17.Fix the hood with a 5 x 45 mm screw (ABSOLUTELY NECESSARY).
18.Connect an exhaust pipe (pipe and clamps are not supplied and must be bought separately)
to the collar B located above the extraction motor unit.
For extractor operation, connect the other end of the exhaust pipe to the home discharge
device. For filter operation, fix the deflector F to the flue support bracket G with 2 screws
and connect the other end of the exhaust pipe to the deflector collar F (if the collar is not
already fitted it should be inserted on the deflector and secured with 1 screw). Once the
steam and fumes have been filtered by the carbon filter (not provided, to be ordered
separately) they are conveyed back to the kitchen through grid H.
19.Carry out the electrical connection.
20.Apply the flues and fix them with 2 screws (
20a) to the flue support G (20b).
21.Slide the bottom section of the flue in the special seat above the hood to completely cover
the extraction unit.
Refit the grease filter/s and check for correct hood operation.
INSTALLATION - ASSEMBLY INSTRUCTIONS
41833036.fm Page 11 Monday, October 18, 2004 5:40 PM
5019 418 33036
DDLE 5790 -
DDXE 5790
FINS N DK GB
1. Control panel.
2. Grease filter.
3. Halogen bulbs.
4. Steam deflector.
5. Telescopic flue.
To clean the grease filter
Wash the grease filter at least once a month.
1. Disconnect the electrical power supply.
2. Remove the grease filters -Fig. 2: pull the
spring release handle (f) downwards, then
remove the filter.
3. After cleaning the grease filter, remount in
reverse order ensuring the entire
extraction surface is covered.
Carbon filter Fitting and
Maintenance
Fitting the carbon filter:
1. Disconnect the electrical power supply.
2. Remove the grease filter (f - Fig. 2).
3. Turn the side knobs 90° and then remove
the filter holder (g - Fig. 3).
4. Fit the carbon filter (h - Fig. 3) in the filter
holder (i - Fig. 3).
5. Refit the filter holder and secure it to the
hood with the screw (g - Fig. 3).
6. Refit the grease filter.
Carbon filter maintenance:
Unlike traditional carbon filters, this carbon
filter can be washed and reactivated.
With normal hood use, the filter should be
cleaned once a month. The best way to clean
the filter is in a dishwasher at the highest
temperature possible, using a normal
dishwasher detergent. To avoid particles of
food or dirt settling on the filter during
washing and giving rise to unpleasant smells,
it is advisable to wash the filter on its own.
After washing, dry the filter in the oven at
100°C for 10 minutes to reactivate it.
The filter will retain its odour-absorbing
capacity for three years, after which it must be
replaced.
Replacing bulbs
1. Disconnect the electrical power supply.
2. Use a small screwdriver or any other suitable
tool to prise off (m-Fig.4) the lamp cover
(p-Fig. 4).
3. Remove the burnt-out bulb.
Replace using 20 W max halogen bulbs
only, making sure not to touch them with
your hands.
4. Close the lighting unit (snap-close).
CONTROL PANEL
A. Light ON/OFF switch.
B. ON/OFF and speed 1 selector switch
(small amount of steam and fumes).
B+C.Speed 2 selector switch
(medium amount of steam and fumes).
B+D.Speed 3 selector switch
(large amount of steam and fumes).
ABCD
5
1
3
4
2
f1
f2
FIG. 1
FIG. 4
FIG. 2
FIG. 3
PRODUCT SHEET
41833036.fm Page 12 Monday, October 18, 2004 5:40 PM
1 / 1

Bauknecht DDLE 5790 IN Program Chart

Category
Cooker hoods
Type
Program Chart

Bauknecht DDLE 5790 IN is a versatile and powerful kitchen appliance that combines a cooker hood and an extractor fan into one sleek unit. With three speed settings, it effectively removes steam, fumes, and odors from your cooking, leaving your kitchen fresh and clean. The halogen bulbs provide bright illumination for your cooking surface, while the grease filters are easily removable for cleaning. Whether you're boiling, frying, or grilling, the Bauknecht DDLE 5790 IN is an essential tool for any modern kitchen.

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Ask the document

in other languages