IS0692 Rev. F 2020 ©Focal Point, LLC 4141 S. Pulaski Rd., Chicago, IL 60632 | www.focalpointlights.com 1 of 5
Seem™ 1 wall to ceiling corners
FSM1-CXF
C - Ceiling
W - Wall
Luminaires must be installed by a qualified electrician (check with local and national codes for proper installation).
To prevent electrical shock, disconnect electrical supply before installation or servicing.
LUMINAIRE MUST BE INSTALLED PRIOR TO DRYWALL.
Configurations are run speCifiC, please Consult faCtory draWings before beginning installation.
ex whip
*
2" x 6"
framing
feed
ceiling height
specied luminaire length
specied luminaire length
foCal point key
poWer off
poWer on
attention
u - individual
s - start of run
i - intermediate
parts lists
e - end of run
inCluded hardWare
shipped installed
tie Wire braCket
(a38635-01)
tie-Wire braCket sCreW (72010)
(8-18 x 1/4 self tapping sCreW)
refleCtor sCreW (72026)
(8-18 x 1/4 self tapping sCreW)
2.0”
1.67”
2.94
3.87”
2"x6" framing
reQuired on both
sides of of housing
Corner units
product id location
produCt id
label on
refleCtor
IS0692 Rev. F 2020 ©Focal Point, LLC 4141 S. Pulaski Rd., Chicago, IL 60632 | www.focalpointlights.com 2 of 5
Luminaires must be installed by a qualified electrician (check with local and national codes for proper installation).
To prevent electrical shock, disconnect electrical supply before installation or servicing.
CEILING UNITS ONLY
1
AVOID ALL CONTACT WITH LED SURFACE,
LEDs ARE EASILY DAMAGED!
11
2INDIVIDUAL AND
FEED LOCATION ONLY
3c
SECURE TO STRUCTURE ABOVE
3b
3a
OPTIONAL OPTIONAL OPTIONAL
INDIVIDUAL AND
FEED LOCATION ONLY
7
STAGGER SCREWS AT LEAST 4" APART
Corner units (C & W) installation
6
install dryWall
before Corner units
11
4
INDIVIDUAL AND
FEED LOCATION ONLY
11
5
INDIVIDUAL AND
FEED LOCATION ONLY
LENS MUST BE INSTALLED
PRIOR TO DRYWALL
INSTALLATION
IS0692 Rev. F 2020 ©Focal Point, LLC 4141 S. Pulaski Rd., Chicago, IL 60632 | www.focalpointlights.com 3 of 5
Luminaires must be installed by a qualified electrician (check with local and national codes for proper installation).
To prevent electrical shock, disconnect electrical supply before installation or servicing.
Continue installing remaining Ceiling units
15
make electrical connection
16 11
17
11
1113
seCure
Ceiling unit to
struCture
above
(optional)
1110
9
ConneCt flex Whip
to Ceiling unit
DO NOT DRIVE SCREWS AT AN ANGLE
8
12 x2
14
IS0692 Rev. F 2020 ©Focal Point, LLC 4141 S. Pulaski Rd., Chicago, IL 60632 | www.focalpointlights.com 4 of 5
Luminaires must be installed by a qualified electrician (check with local and national codes for proper installation).
To prevent electrical shock, disconnect electrical supply before installation or servicing.
install remaining Wall housings
21 22 23
dryWall
installs
behind
mud flange
18
dryWall installs behind
mud flange
19
STAGGER SCREWS AT LEAST 4" APART
DO NOT DRIVE SCREWS AT AN ANGLE
20
DO NOT DRIVE SCREWS AT AN ANGLE
25
24
STAGGER SCREWS
AT LEAST 4" APART
Contractor is responsible for adequately reinforcing walls and/or ceilings to support luminaire weight. Focal Point, LLC accepts no responsibility for inadequately reinforced walls
and/or ceilings. The information contained in this drawing is the sole property of Focal Point, LLC. Any reproduction in part or whole without the written permission of Focal Point, LLC
is prohibited.
IS0692 Rev. F 2020 ©Focal Point, LLC 4141 S. Pulaski Rd., Chicago, IL 60632 | www.focalpointlights.com 5 of 5
driVer SerVice
11
2
11
1
AVOID ALL CONTACT WITH LED SURFACE,
LEDs ARE EASILY DAMAGED!
26
dryWall
mud
tape and mud
27
/