Legrand IS-AC1020_REV.A Installation guide

301 Fulling Mill Road, Suite G

Middletown, PA 17057

Phone (800) 321-2343 / Fax (717) 702-2546

www.onqlegrand.com

INSTRUCTION/INSTALLATION SHEET

Mounting Bracket for 3

Party Enclosures

IS-0437 REV. A

1. Introduction

The On-Q/Legrand Mounting Bracket for 3

Party Enclosures

(P/N AC1020) is designed to mount any On-Q Module in

Leviton, Open House, Channel Vision, GE, Honeywell,

USTec and Vantage Prolan enclosures. (see Figure 1).

2. Installation

This Mounting Bracket is drilled for multiple enclosures,

identified by ‘A’, ‘B’ and ’C’ labels as follows:

‘A’ – Use with USTec/Vantage enclosures

‘B’ – Use with Leviton and Open House enclosures

‘C’ – Use with Channel Vision enclosures

The Mounting Bracket is shipped with four plungers and

grommets and four screws to accommodate all mounting

scenarios.

NOTE: To complete the installation, simply find which set

of letter labeled holes line up for your enclosure style,

and use one plunger and grommet set or screw in the

designated hole in each corner of the bracket to mount it

to the enclosure.

NOTE: The On-Q Module is then mounted onto the

Mounting Bracket using the On-Q style tab and plunger

method of installation.

Figure 1