2. Legrand
  3. 3 Bay Module

Legrand 3 Bay Module, 3 Bay Module Mounting Bracket - F7510, F7510 Installation guide

  • Hello! I am an AI chatbot trained to assist you with the Legrand 3 Bay Module Installation guide. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!
301 Fulling Mill Road, Suite G
Middletown, PA 17057
Phone (800) 321-2343 / Fax (717) 702-2546
www.onqlegrand.com
Page 1 of 2
©Copyright 2008 by On-Q/Legrand All Rights Reserved.
INSTRUCTION/INSTALLATION SHEET
3-Bay Module Mounting Bracket
IS-0411 REV. O
1. Introduction
The On-Q/Legrand 3-Bay Mounting Bracket (P/N F7510) is designed to mount up to three single bay modules in
virtually any enclosure, including all On-Q styles as well as Leviton and Open House enclosures.
2. Description
The On-Q 3-Bay Module Mounting Bracket, is designed to be mounted in the enclosures with multiple push-pins
(typically one at each corner) in one of two orientations (see Figure 1 and call out for video (RF coax) module
installations and Figure 2 and call out for phone and data (Cat 5e) module installations. Up to three single bay
modules) can then be mounted in the bracket, using push-pins at the corners of the modules.
3. Installation
The On-Q 3-Bay Module Mounting Bracket is typically installed during “trim-out” or as an upgrade for an existing
installation.
A. Bracket installation for use with Video Modules.
1. Hold the bracket so that the module openings are pointing
upward.
2. Insert one grommet into each of the four holes on the inside of
the bracket (see Figure 1 and its callout and Figure 3).
NOTE: The brackets are designed to work with other
manufacturer’s enclosures. Use Figure 3 as a reference for
which holes to use with which manufacturer. (#1 = Greyfox or
Pass and Seymour, #2 = Open House or Leviton and #3 = On-Q.
3. Insert a plunger into each grommet and pull back on the
plungers, once inserted, to insure they are unlatched.
4. Line up the bracket with the appropriate holes in the enclosure,
and push in the plungers to latch the grommets and lock the
bracket to the enclosure.
Secure
modules here
with push-pins
Figure 3
301 Fulling Mill Road, Suite G
Middletown, PA 17057
Phone (800) 321-2343 / Fax (717) 702-2546
www.onqlegrand.com
Page 2 of 2
©Copyright 2008 by On-Q/Legrand All Rights Reserved.
INSTRUCTION/INSTALLATION SHEET
3-Bay Module Mounting Bracket
IS-0411 REV. O
B. Bracket installation for use with Phone or Data Modules.
1. Hold the bracket so that the module openings are pointing
outward.
2. Insert one grommet into each of the four holes on the inside of
the bracket (see Figure 2 and its callout and Figure 4).
NOTE: The brackets are designed to work with other
manufacturer’s enclosures. Use Figure 4 as a reference for
which holes to use with which manufacturer. (#1 = Greyfox or
Pass and Seymour, #2 = Open House or Leviton and #3 = On-Q.
3. Insert a plunger into each grommet and pull back on the
plungers, once inserted, to insure they are unlatched.
4. Line up the bracket with the appropriate holes in the enclosure,
and push in the plungers to latch the grommets and lock the
bracket to the enclosure.
Figure 4
/