ABOUT YOUR INFINEA® BLUEPAD CHARGING STATION (5-Unit)
ASSEMBLY
Infinea
®
BluePad
Charging Station (5-Unit)
QUICK START GUIDE
CHARGE STATUS
TROUBLESHOOTING
Cooler Vent
Attachment
LED Indicator
DC Jack Port
1. Place the Infinea BluePad Charging
Station on a sturdy, clean and dry surface
in an open, well-ventilated area away
from direct sunlight.
2. Insert the included AC adapter plug into
the DC Jack Port on the charger.
3. Connect the AC power adapter to a
power outlet.
4. Gentley insert the unit into a charging
bay, ensuring that the battery contacts
are aligned with the charging bay’s
contacts. The LED lights up with the
charging status.
The Infinea BluePad Charging Station uses LEDs
to indicate the charge status.
Check the LED next to each charging bay to verify
charging status. prior to use.
STATUS INDICATOR LEDS
Green Inserted device is fully charged.
Orange Inserted device is charging.
Flashing Red Over-current protection is enabled.
Charging bay is at or above maximum
fault current (1.9A) and has stopped
working.
Solid Red* Over-current protection is enabled due
to excessive temperature fault (over
60°C/140°F).
No LED** Indicates there is no device in charging
bay or there is no power supply
attached the charger.
*When the LED is solid red and the operating
temperature has decreased to at or below 55°C/131°F,
the charging bay begins working again.
**No LED may also indicate over-current protection is
enabled if the charging pins are shorted, or there is no
load.
The LED does not come on when a unit is
inserted.
• Ensure the power supply is securely
inserted into both the power outlet and the
DC port on the charging station
• Ensure the unit is properly seating in the
charging bay
It takes an excessive amount of time to fully
charge the battery.
• Verify ambient temperature meets the
operating temperature requirements
Operating: 0°C – 40°C (32°F – 104°F)
Please visit our website at ipcmobile.com,
or contact your Innite Peripherals account
representative, for additional information
about our current and future product accessory
oerings.
ACCESSORIES
Mobility Sales/Technical Center
Innite Peripherals, Inc.
17681 Mitchell N.
Irvine, CA 92614
Toll-Free: (866) 278-7860
Oce: (949) 222-0300
Headquarters/Main Warehouse
Innite Peripherals, Inc.
2312 Touhy Ave.
Elk Grove Village, IL 60004
Toll-Free: (800) 278-7860
Oce: (847) 818-1260
Fax: (847) 818-1287
Technical Support
Innite Peripherals, Inc.
17681 Mitchell N.
Irvine, CA 92614
Toll-Free: (866) 278-7860
Oce: (949) 222-0300
Email
Website
ipcmobile.com
•
Note: Box contents and part numbers may vary
based on order configuration.
Infinite Peripherals does not warrant, and is
not responsible for, any damage to the Infinea
BluePad Charging Station (“Product”) as a
result of liquid or solid particle intrusion into
the Product or damage caused by dropping
the Product. If a material or workmanship
defect arises with regard to any Infinite
Peripherals product, and a valid claim is
received within the Warranty Period, Infinite
Peripherals (at its sole discretion) will (1)
repair the Product using new or refurbished
parts or (2) replace the Product with a new
or refurbished Product. For purposes of
this limited warranty, “refurbished” means a
product or part that has been substantially
returned to its original specifications. In the
event of a defect, these are your exclusive
remedies.
QSG-10027 Rev B
WARNINGS & CAUTIONS
Please observe the following precautions:
• Do not immerse the charger in water.
• When not in use, store the charger in a
cool dry place.
• Do not store or operate the charger near a
heat source.
• The charger is information technology
equipment and for oce use only, and
should only be used for its intended
purpose.
• The output power drawn from the supply
must not exceed the rating for this
product.
• The power to the device should be
removed by unplugging the AC main
plug.
• Do not use any other AC adapter other
than the adapter supplied with this
charger. Use of any other adapter may
damage the charger and will void the
warranty.
ADDITIONAL INFORMATION
Contact your Infinite Peripherals sales
representative for technical specifications and
additional product documentation.
WARRANTY
PRODUCT RETURNS
Use the link provided to create an account
and gain access to our Knowledge Base and
online support services. Through our online
support center, you’ll be able to download
files, open a Support Ticket, manage your
RMAs, view your account Profile and
subscribe to Alerts.
To Request an RMA:
1. Create a user account in the RMA
Support Portal at https://ipcmobile.com/
support/rma/
2. Login to your user account and then
click Create RMA Request.
3. Read the instructions provided and
complete the online request form.
4. Note the assigned RMA number and
write it clearly on your shipping carton.
5. Ship your equipment back to us at the
address provided.
Specications subject to change without notice. Innite
Peripherals, Mobilize Your Enterprise, Linea Pro, Innea, Innea
Tab and Innea Omni are trademarks of Innite Peripherals, Inc.
All other trademarks are the property of their respective owners.
CONTACT US
/
