Infinite Peripherals CBL-CUP-LP5PC-BK Quick start guide

Brand: Infinite Peripherals

Model: CBL-CUP-LP5PC-BK

Type: Quick start guide

Infinite Peripherals CBL-CUP-LP5PC-BK is a charging cup designed for Linea Pro 5 devices. It allows for easy charging of the Linea Pro 5 by simply clipping the cup onto the bottom of the device. The cup has a green LED indicator to show that charging is active. It is compatible with both the standard Linea Pro 5 and the Linea Pro 5 with Rugged Case. The cup is lightweight and has a 3-foot cable, making it easy to use and store.

ABOUT YOUR LINEA PRO 5 CHARGING CUP

GETTING STARTED

QUICK START GUIDE

PRODUCT SPECIFICATIONS

Removal

Installation

Mechanical

Compatibility: Linea Pro 5 Standard with

- iPod 5th generation

- iPhone 5

Linea Pro 5 w/Rugged Case with

- iPod 5th generation

- iPhone 5

Weight: 56 g (1.98 oz.) 57 g (2.01 oz.)

Dimensions: 74.4 mm x 57.9 mm x 29.3 mm

(2.93” x 2.28” x 1.15”)

80.8 mm x 63.4 mm x 35.1 mm

(3.18” x 2.50” x 1.38”)

Cable Length: 3’

Electrical

Connector: USB A

Input: 5.2V 2.4A DC

Environmental

Operating Temperature: 32°F to 95°F (0°C to 35°C)

Storage Temperature: -4°F to 113°F (-20°C to 45°C)

Linea Pro

Charging Cup

INSTALLATION (See Installation Diagram)

1. Ensure that the environmental conditions

are within appropriate operating

specifications for the charger, as well as

for the Linea Pro 5 and iOS device.

2. Clip the charging cup onto the bottom of

Linea Pro 5 device and check that cup is

properly aligned and fully seated on the

bottom of the Linea Pro 5 device.

3. Plug USB connector end of Linea Pro 5

Charging Cup into appropriate power

supply (5.2V 2.4A, not included).

4. Confirm that the Linea Pro 5 LED

indicator turns green to indicate charging

is active.

REMOVAL

(See Removal Diagram)

1. Grip the bottom of the cup with palm of

hand.

2. Pull down on the rear tab with fingertips

to unlock cup from device.

3. Separate the charging cup from the

device.

The following table describes Linea Pro 5 Charging Cup speciﬁcations.

Please visit our website at ipcmobile.com,

or contact your Inﬁnite Peripherals account

representative, for additional information

about our current and future product

accessory oerings.

ACCESSORIES

Mobility Sales/Technical Center

nite Peripherals, Inc.

17681 M

chell N

rvine, CA 92614

Toll-Free: (866) 278-7860

Office: (949) 222-0300

Headquarters/Main Warehouse

Innite Peripherals, Inc.

2312 Touhy Ave.

Elk Grove Village, IL 60004

Toll-Free: (800) 278-7860

Oce: (847) 818-1260

Fax: (847) 818-1287

Specications subject to change without notice. Innite Peripherals,

Mobilize Your Enterprise, Linea Pro, Innea, Innea Tab and Innea Omni

are trademarks of Innite Peripherals, Inc. All other trademarks are the

property of their respective owners.

Technical Support

nite Peripherals, Inc.

17681 M

chell N

rvine, CA 92614

Toll-Free: (866) 278-7860

Office: (949) 222-0300

[email protected]

Website

ipcmobile.com

•

Note: Box contents and part numbers may vary based on order

configuration.

Inﬁnite Peripherals does not warrant, and is

not responsible for, any damage to the Linea

Pro 5 Charging Cup (“Product”) as a result

of liquid or solid particle intrusion into the

Product or damage caused by dropping the

Product. If a material or workmanship defect

arises with regard to any Inﬁnite Peripherals

product, and a valid claim is received within the

Warranty Period, Inﬁnite Peripherals (at its sole

discretion) will: (1) repair the Product using new

or refurbished parts, or (2) replace the Product

with a new or refurbished Product. For purposes

of this limited warranty, “refurbished” means

a product or part that has been substantially

returned to its original speciﬁcations. In the event

of a defect, these are your exclusive remedies.

QSG-10024 Rev. B

WARNINGS & CAUTIONS

Please observe the following precautions:

• Keep the charger away from liquids. Do

not immerse the charger in water.

• The charger is intended for Indoor use

only. When not in use, place the charger

in a cool, dry place.

• Do not place the charger near a heat

source. Keep both the power supply and

charger away from direct sunlight and/or

heat.

• Device should only be repaired by IPC or

an authorized service facility.

• Do not use any USB connector other than

the one provided with this charger. The

use of any other USB connector may

damage the charger and will void the

warranty.

WARRANTY

TROUBLESHOOTING

Note: iOS device and other additional items shown

on cover page may not be included.

PRODUCT RETURNS

Visit our online support center at

https://ipcmobile.com/support/rma. Use

the link provided to create an account and

gain access to our Knowledge Base and

online support services. Through our

online support center, you’ll be able to

download files, open a Support Ticket,

manage your RMAs, view your account

Proﬁ

le and subscribe to Alerts.

To Request a RMA:

1. Create a user account in the RMA

Support Portal at https://ipcmobile.

com/support/rma.

2. Login to your user account and click the

Create RMA Request option.

3. Read the instructions provided and

complete the online request form.

4. Note the assigned RMA number and

write it clearly on your shipping carton.

5. Ship your equipment back to us at the

address provided.

ADDITIONAL INFORMATION

Please contact your Inﬁnite Peripherals sales

representative for technical speciﬁcations and

additional product documentation.

No LED illuminated on Linea Pro 5.

• The USB connector is not properly

connected.

• The Linea Pro 5 is not seated properly in

the charging cup.

The LED is illuminated on the Linea Pro 5 upon

installation but then turns o.

• Faulty charging cup.

• Faulty device.

Infinite Peripherals CBL-CUP-LP5PC-BK Quick start guide

Infinite Peripherals CBL-CUP-LP5PC-BK Quick start guide

Infinite Peripherals CBL-CUP-LP5PC-BK Quick start guide

Related papers

Other documents