Infinite Peripherals Infinea Tab M Quick start guide

Brand
Infinite Peripherals
Model
Infinea Tab M
Type
Quick start guide
ABOUT YOUR INFINEA TAB M® for iPHONE 6 PLUS
CHARGING STATION (5-Unit)
ASSEMBLY
Infinea Tab
®
M for
iPhone 6 Plus
Charging Station
(5-Unit)
QUICK START GUIDE
CHARGE STATUS
2
TROUBLESHOOTING
CHARGING BAY
COOLING VENT
CHARGING CONTACTS
ATTACHMENT
LED INDICATOR
Infinea Tab M for iPhone 6 Plus Charging Station (5-Unit) - Standard Case
Infinea Tab M for iPhone 6 Plus Charging Station (5-Unit) - Rugged Case
1. Place the Infinea Tab M for iPhone 6 Plus
Charging Station on a sturdy, clean and
dry surface in an open, well-ventilated
area away from direct sunlight.
2. Insert the included AC adapter plug into
the DC Jack Port on the charger. Then
connect the AC power adapter to a power
outlet.
3. Insert the Infinea Tab M for iPhone 6 Plus
unit into a charging bay, ensuring that the
battery contacts are aligned with the bay’s
contacts. The LED will light up to provide
the charging status.
The Infinea Tab M for iPhone 6 Plus Charging
Station (5-Unit) uses a tricolor LED to indicate
the charge status.
Check the status LED on each slot to verify
normal charging status. When the battery is fully
charged, the LED indicator will be green.
Status Indicator LEDS
Green Inserted device is fully charged.
Orange Inserted device is charging.
Flashing Red Over-current protection is enabled.
Charging bay is at or above
maximum current fault (1.9A) and
has stopped working.
Solid Red Over-current protection is enabled
due to overheat fault (over
0°C/140°F).
No LED Indicates there is no device in
charging bay or there is no power
supply attached the charger.
Note 1: When the LED is solid red and the operating
temperature has decreased to at or below 55°C/131°F,
the charging bay will begin working again.
Note 2: No LED may also indicate over-current
protection is enabled if the charging pins are shorted,
or there is no load.
The LED does not come on when a unit is
inserted.
• Ensure that the power supply is fully
plugged into the outlet and plugged into
the DC port.
It takes an excessive amount of time to fully
charge the battery.
• Verify ambient temperature meets the
operating temperature requirements.
Operating: 0°C – 40°C (32°F – 104°F)
There are no accessories currently available
for the Infinea Tab M for iPhone 6 Plus
Charging Stations. Please visit our website
at ipcmobile.com, or contact your Infinite
Peripherals (IPC) account representative, for
additional information about our current and
future product accessory oerings.
ACCESSORIES
Mobility Sales/Technical Center
Infinite Peripherals, Inc.
17681 Mitchell N
Irvine, CA 92614
Toll-Free: (866) 278-7860
Office: (949) 222-0300
Headquarters/Main Warehouse
Infinite Peripherals, Inc.
2312 Touhy Ave.
Elk Grove Village, IL 60004
Toll-Free: (800) 278-7860
O
ce: (847) 818-1260
Fax: (847) 818-1287
Infinea is a registered trademark of Infinite Peripherals, Inc.
Technical Support
Infinite Peripherals, Inc.
17681 Mitchell N
Irvine, CA 92614
Toll-Free: (866) 278-7860
Office: (949) 222-0300
Email
[email protected]
Website
ipcmobile.com
•
Note: Box contents and part numbers may vary based on order
configuration.
WARRANTY
Infinite Peripherals (IPC) does not warrant, and is not responsible for,
any damage to the Infinea Tab M for iPhone 6 Plus Charging Station
(“Product”) as a result of liquid or solid particle intrusion into the
Product or damage caused by dropping the Product. If a material
or workmanship defect arises with regard to any IPC product, and a
valid claim is received within the Warranty Period, IPC (at IPC’s sole
discretion) will (1) repair the Product using new or refurbished parts
or (2) replace the Product with a new or refurbished Product. For
purposes of this limited warranty, “refurbished” means a product or
part that has been substantially returned to its original specifications.
In the event of a defect, these are your exclusive remedies.
QSG-10021 Rev. A
WARNINGS & CAUTIONS
Please observe the following precautions:
• Do not immerse the charger in water.
• When not in use, store the charger in a cool
dry place.
• Do not store or operate the charger near a
heat source.
• Do not directly connect the charger to an
electrical outlet.
• The charger should only be used for its
intended purpose.
• The output power drawn from the supply
must not exceed the rating for this product.
• The power to the device should be removed
by unplugging the AC main plug.
• Do not use any other AC adapter other
than the adapter supplied with this charger.
Use of any other adapter may damage the
charger and will void the warranty.
ADDITIONAL INFORMATION
Please contact your Infinite Peripherals sales representative for technical specifications and additional product documentation.
  • Page 1 1
  • Page 2 2

Infinite Peripherals Infinea Tab M Quick start guide

Brand
Infinite Peripherals
Model
Infinea Tab M
Type
Quick start guide
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents