2. Skov
  3. Rack and Pinion DA 75 24-230V

Skov Rack and Pinion DA 75 24-230V Mounting Guide

  • Hello! I'm your chat assistant and I've read the SKOV Rack & Pinion DA 75 24/230V Mounting and Installation Guide. This document provides comprehensive instructions on how to mount the device and adjust the pinion housings and limit switches, also includes wiring diagrams for 24V and 230V setups. I'm ready to help you with any questions you might have about this.
  • What size holes should be drilled for mounting?
    When should the chain be mounted in the gear motor?
    How much should the rubber seal be squeezed during pinion housing adjustment?
2022.05.04 • 604023
Rack & Pinion DA 75
24/230V
Mounting and Installation Guide
Mounting and Installation Guide
Rack & Pinion DA 75 24/230V
Mounting the drive shaft and motor
Mounting the gerarbox on the span bars with 4
pcs. M10 x 25 with locknuts and washers.
Mount the unit on the door frame in that way
that the motor sharft is in line with the drive
sharft.
Motor mounted on the drive shaft.
Drill two holes ø8.5mm.
Mount the clutch on the drive sharft.
Cutting the drive shaft.
Mounting and Installation Guide
Rack & Pinion DA 75 24/230V
Adjusting the pinion housings and limit switches
Do not mounted the chain into the gear motor before
the motor is in fully closed position.
Make sure that the door is completely closed from
one end to the other by using the supports.
Using the supports to keep the door in closed
position
Tighten at least one of the two tailstock screws in the
first pinion house, so the rubber seal is squeezed
about 50% , remove the supports and turn the motor
towards opening a bit so you can see a gab.(About
25mm) Adjust the rest of the pinion houses so the
gab are same from one end to the other.
Turn the motor towards open position, and make
sure the door can operate in the full movement
without hitting any materials inside the house, and
that it stops before it hit the bolt at the end of the
rack.
Open and close the door few times and carry out the
final adjustment, so the door closes tightly.
SKOV A/S • Hedelund 4 • Glyngøre • DK-7870 Roslev
Tel. +45 72 17 55 55 • Fax +45 72 17 59 59 • www.skov.com • E-mail: skov@skov.dk
Circuit Diagrams for DA 75 24V
For motor placed on left side of the drive-shaft
interchange W106 1 and 3.
Circuit Diagrams DA 75 230V
K1: DOL 539 computer
For exact connection, see setup menu Show Installation in DOL 539 computer.
2022.05.04 • 604023 • 3.7.1.1 • EN • Made in Denmark
Ex. of terminal number
For correct connection
see the setup menu
Show Installation in
DOL 539
Ex. of terminal number
For correct connection
see the setup menu
Show Installation in
DOL 539
/