Whirlpool AKR 640 AL Program Chart

Brand: Whirlpool

Model: AKR 640 AL

Category: Cooker hoods

Type: Program Chart

This manual is also suitable for

AKR 921 AL



5019 318 33032

AKR 921 - AKR 640

INSTALLATIONSANGABEN

Mindestabstand zur Kochfläche: 50 cm (Elektrokochplatten), 75 cm (Gas-, Öl-

oder Kohlekochplatten). Folgen Sie bei der Installation der Nummerierung

.....) und den jeweiligen Anleitungen. Schließen Sie das Gerät erst

nach erfolgter Installation an die Stromversorgung an.

INSTALLATION SHEET

Minimum height above cooker: 50 cm (electric cookers), 75 cm (gas, gas oil or

coal cookers). To assemble follow the numbers (1

.....) and relative

instructions. Do not connect the appliance to the electrical power supply until

installation is completed.

FICHE D'INSTALLATION

Distance minimale par rapport à la cuisinière : 50 cm (cuisinière électrique),

75 cm (cuisinière à gaz, mazout ou charbon). Pour le montage, suivez la

numérotation (1

.....) et les instructions correspondantes. Ne branchez

pas l'appareil tant que l'installation n'est pas terminée.

INSTALLATIEKAART

Minimumafstand tot het kooktoestel: 50 cm (elektrische kooktoestellen), 75 cm

(kooktoestellen op gas, olie of kolen). Volg voor de montage de nummering

.....) en de bijbehorende aanwijzigngen. Geef het apparaat geen

stroom totdat de installatie geheel voltooid is.

FICHA DE INSTALACIÓN

Distancia mínima desde los quemadores: 50 cm (quemadores eléctricos), 75 cm

(quemadores de gas, gasóleo o carbón). Para efectuar el montaje siga la

numeración (1

.....) y las instrucciones. No enchufe el aparato hasta que

su instalación no esté terminada.

FICHA DE INSTALAÇÃO

Distância mínima dos fogões: 50 cm (fogões eléctricos), 75 cm (fogões a gás,

gasóleo ou carbono). Para a montagem, siga a numeração (1

.....) e as

respectivas instruções. Não ligue o aparelho à corrente eléctrica até a instalação

estar concluída.

SCHEDA INSTALLAZIONE

Distanza minima dai fuochi: 50 cm (fuochi elettrici), 75 cm (fuochi a gas,

gasolio o carbone). Per il montaggio seguire la numerazione (1

.....) e le

istruzioni relative. Non dare corrente allapparecchio finché linstallazione non è

totalmente completata.

ùüùü+ùùùþ

ü$12.)12.1.)2"0120" FP02!"0120" FP0120"

.0! #02!0. #0! # +.22  21.  #1202

.!1





.2"1$02" /0"2! 3 / 2020002!)

!0*.21#10#!2  !&12"0.212.1"

31833032.fm5 Page 1 Tuesday, January 22, 2002 2:57 PM



5019 318 33032

AKR 921 - AKR 640

31833032.fm5 Page 2 Tuesday, January 22, 2002 2:57 PM



5019 318 33032

AKR 921 - AKR 640

Preliminary information for installing the hood:

Disconnect the power supply at the home main switch during electrical connections. Remove the grease filter.

Place the extraction unit on a flat surface and fit the bottom part of the hood on it

(remove the grease filter/s).

Carry out the electrical connections between the two parts.

Fix the hood to the extraction unit with 10 screws.

Using a pencil, draw the centre line on the wall up to the ceiling to facilitate installation operations.

Attach the hole diagram to the wall: the vertical centre line printed on the hole diagram must match the

centre line drawn on the wall, and the lower edge of the hole diagram must match the lower edge of the

hood: remember that with installation completed the bottom of the hood must be at least 50 cm above

the cooktop in case of electric cookers and 75 cm in case of gas or mixed cookers.

Place the support bracket on the hole diagram so that it matches the dashed rectangle, mark the two

external holes and drill, remove the hole diagram, insert 2 wall plugs and fix the hood support bracket

with two 5x45 mm screws.

Hook the hood to the bracket.

Adjust the distance between the hood and the wall.

Adjust the hood horizontally.

10.

From the inside of the extraction unit, mark the holes for fixing the hood.

11.

Remove the hood from the bracket.

12.

Drill on the mark (Ø 8 mm - see step 10).

13.

Insert 1 wall plug.

14.

Fit the flue support bracket

to the wall and against the ceiling, use the support bracket as hole diagram

(the small slot on the support must match the line drawn on the wall - step 4) and mark 2 holes with the

pencil, drill the holes (Ø 8 mm), and finally insert 2 plugs.

15.

Fix the flue support bracket to the wall with two 5x45 mm screws.

16.

Hook the hood to the bottom bracket.

17.

Fix the hood to the wall with a 5x45 mm screw (ABSOLUTELY NECESSARY).

18.

Connect an exhaust pipe (pipe and clamps are not supplied and must be bought separately) to the collar

located above the extraction motor unit.

For extractor operation, connect the other end of the exhaust pipe to the home discharge device. For filter

operation, fix the deflector

to the flue support bracket

with 2 screws and connect the other end of

the exhaust pipe to the deflector collar

(if the collar is not already fitted it should be inserted on the

deflector and secured with 1 screw). Once the steam and fumes have been filtered by the carbon filter

(not provided, to be ordered separately) they are conveyed back to the kitchen through grid

19.

Carry out the electrical connection.

20.

Apply the flues and fix them with 2 screws (20a) to the flue support

(20b).

21.

Slide the bottom section of the flue in the special seat above the hood to completely cover the extraction

unit.

Refit the grease filter and check for correct hood operation.

INSTALLATION - ASSEMBLY INSTRUCTIONS

D F NL E

P I GR

31833032.fm5 Page 5 Tuesday, January 22, 2002 2:57 PM



5019 318 33032

AKR 921 - AKR 640

Control panel.

Grease filter.

Halogen bulbs.

Steam deflector.

Telescopic flue.

To clean the grease filter

Wash the grease filter at least once a month.

Disconnect the electrical power supply.

Remove the grease filters -

Fig. 1

: pull the spring

release handle

(f)

downwards, then remove the

filter.

After cleaning the grease filter refit in reverse

order, making sure the entire extraction surface

is covered.

Carbon filter Fitting and Maintenance

Fitting the carbon filter:

Disconnect the electrical power supply.

Remove the grease filter

(f - Fig. 1)

Remove the screw and then the filter holder

(g - Fig. 2)

Fit the carbon filter

(h - Fig. 2)

in the filter

holder

(i - Fig. 2).

Refit the filter holder and secure it to the hood

with the screw

(g - Fig. 2)

Refit the grease filter.

Carbon filter maintenance:

Unlike traditional carbon filters, this carbon filter can

be washed and reactivated.

With normal hood use, the filter should be cleaned

once a month. The best way to clean the filter is in a

dishwasher at the highest temperature possible,

using a normal dishwasher detergent. To avoid

particles of food or dirt settling on the filter during

washing and giving rise to unpleasant smells, it is

advisable to wash the filter on its own. After

washing, dry the filter in the oven at 100° C for

10 minutes to reactivate it.

The filter will retain its odour-absorbing capacity for

three years, after which it must be replaced.

Replacing bulbs

Disconnect the electrical power supply.

Use a small screwdriver or any other suitable tool

to prise off

(m-Fig. 3)

the lamp cover

(p-Fig. 3)

Remove the burnt-out bulb.

Replace using 20 W max halogen bulbs only,

making sure not to touch them with your hands.

Close the lighting unit (snap-close).

CONTROL PANEL

Light ON/OFF switch.

ON/OFF and speed 1 selector switch

(small amount of steam and fumes).

Speed 2 selector switch

(medium amount of steam and fumes).

C+D.

Speed 3 selector switch

(large amount of steam and fumes).

Fig. 1

Fig. 2

Fig. 3

D F NL E

P I GR

PRODUCT SHEET

31833032.fm5 Page 6 Tuesday, January 22, 2002 2:57 PM

Whirlpool AKR 640 AL Program Chart

Brand: Whirlpool

Model: AKR 640 AL

Category: Cooker hoods

Type: Program Chart

This manual is also suitable for

AKR 921 AL

Download PDF

report

Whirlpool AKR 640 AL Program Chart

This manual is also suitable for

Whirlpool AKR 640 AL Program Chart

Related papers

Other documents